0
Add your answer:
Earn +20 pts
What is the voltage of telephone line in Pakistan ptcl?
it has 52volt dc off hook
Is transmission voltage a phase to phase voltage or a phase to ground voltage?
Phase to Phase voltageCorrection to the above answer:There is no such thing as a 'phase-to-phase' or 'phase-to-ground' voltage. The correct terms are 'line-to-line' (or 'line voltage') and 'line-to-ground' (or 'phase voltage'). Transmission-line voltages are line-to-line (or 'line') voltages.
A telephone-repair technician uses a meter to measure voltage on a phone line. This meter is an example of .?
it is hardware not software
What is edge speed in electronics?
A voltage is applied to a signal line. The voltage of the line changes gradually from 0 to +V. The "edge speed" is the rate of change of voltage of the line. A voltage is applied to a signal line. The voltage of the line changes gradually from 0 to +V. The "edge speed" is the rate of change of voltage of the line.
What voltage and Hz does Pakistan use?
220VAC at 50Hz
From which country does the Durand Line Separate Pakistan?
Durand Line separates Pakistan from Afghanistan
What is the poverty line in Pakistan for 2010?
poverty line in Pakistan for 2009 was 848.79 rupees.
How do you convert 3 phase RMS line-line voltage to RMS line-neutral voltage on an unbalance system Basically how do you calculate using trig for all 3 phase?
The term, 'unbalanced system' refers to an unbalanced load. Under normal circumstances, an unbalanced load leads to unbalanced line currents. The line voltages are determined by the supply and remain symmetrical, even when the load is unbalanced. As your question refers to a 'line to neutral' voltage (i.e. a phase voltage), you must be referring to a star (wye) connected load, in which case the phase voltage (line to neutral voltage) is 0.577 (the reciprocal of the square-root of 3) times the line voltage (line to line voltage).
Is 220V line voltage or phase voltage?
Phase, if you are referring to line, as power line from pole.
What is the line voltage between two lines?
the voltage between 1 line & phase =120v The voltage between 2 line =240
Where is the fault line in Pakistan?
The Chaman Fault is the major fault line in Pakistan. It starts just off the coast of Pakistan and travels northeast through Pakistan in into Afghanistan.
What is a line to line voltage?
In a 3 phase system, the voltage measured between any two phase is called line to line voltage.And the voltage measured between line to neutral is called phase to neutral (line to neutral) voltage.AnswerThere is no such thing as a 'phase-to-phase' or a 'phase-to-neutral' voltage. The correct terms are 'line-to-line' and 'line-to-neutral'.The voltage between any two line conductors is called a line voltage.In a three-phase, three-wire, system, the line voltage is numerically equal to the phase voltage.In a three-phase, four-wire, system, the voltage between any line conductor and the neutral conductor is called a phase voltage. The line voltage is 1.732 times larger than the phase voltage.
