Go to www.hmaservice.com and set up a account. "it's free" and then you will find access to wiring and mechanical service data.
tiburon 2.0 Intake air temperature (IAT) sensor lokation?
to the right in the engine hiding in a box the stock air intake. The intake box unclips.
hyundai tiburon 2001 all vacum hoses OK new spark plugs i have spark engine will start but hard to start firing order OK but wont stay on what can it be is it intake sensor or not enough fuel pressure
IAT - Intake(or incomming) air temperature sensor. It will be located along the air intake tube. It is usually either on the airbox or right after. Before you get to the mass airflow sensor. It usually just is held in the tube by a grommet. Undo the connector and pull it out.
remove the top plastic on the right side of the engine and you will the the stock intake, all you need to do is unclip the box and you will see the filter.
theres one under the hood near the stock intake or under the steering wheel theres a little plastic square that pops off.
A person should know the location of the sensors in a vehicle. The IAT sensor is located on the air intake housing of this vehicle.Ê
the starter is located on the intake part of the block in the center of the engine compartment. from the driver side look for the shifter cables on top of the trans axle and it is straight back from there.
You cant chance the spark plugs with out removing the manifold sorry dude i have tried every possible way there is and its not going to happen :(
3-5 horsepower
You have to unbolt the intake and a few other things and move it up to gain enough clearance to remove wires and plug. It took about an hour or so for my first time.
Excuse me, may you mean the iat (not ita) if so, then you will find it in the air intake in your vehicle it refers to: intake air temperature sensor regards,