Want this question answered?
Geophone Are Moving Coil Electromagnetic type principle is contained
If you are working with a coil, you should have all parts of the coil and knowledge to work with them. In the related links box below, I posted a websited which has all this knowledge and another one about builduing the tesla coil.
i have no clue
Moving coil galvanometer is used to detect unknown resitance of the both ac or dc circuits :)deepak instrumentation engineerAnswerA 'galvanometer' is simply an instrument that detects and measures small currents; 'moving coil' describes its operating principle. A moving-coil galvanometer is a d.c. instrument; if subject to a.c., then it will simply vibrate as it will not be able to respond the the frequency (unless the frequency is very low, in which case, it will sweep back and forth in step with that frequency).The moving-coil principle is applied to other instruments, and can be used in the construction of multimeters. In the case of a multimeter, a rectifier circuit is incorporated so that it can be used to measure a.c. currents and voltages.
A moving coil galvanometer is a type of scanning device used in the transportation and trucking industry. The vehicle is pulled through a fixed scanner while an operator watches a closed circuit television.
Geophone Are Moving Coil Electromagnetic type principle is contained
The main principle is that electricity could be sent wireless and he proved it.
It is related to moving coil type instrument
An ammeter consists of a coil with very low resistance. when electric current flows through the coil, the coil induces a magnetic field which turns the needle.
it will smash to each other & make flex
Using a megger you check from either positive or nuetral to ground. The megger should read open (usually OL). It doesnt matter which connection you choose as long as one is ground. If the megger shows anything other than open the windings are bad.
The working principle of these instruments is same as that of the d'Arsonval type of galvanometers, the difference being that a direct reading instrument is provided with a pointer and a scale. The basic principle of this device is the interaction of magnetic field of the compass (a permanent magnet) and the field around the conductor (a simple electromagnet)
By Megger testing (meggering) of the motor any one can measure the IR of the motor. MEGGER is a device used to measure IR. Analog Megger device may generate 500 volts..it gives coil to coil or coil to body IR value...it should not be less than 2 Mega ohm, generally it should be or kept more than 5 mega ohm...thanks ...DEEPAK RAJPUT
could be.... coil ... coil wire or... pick up coil.. not working
The working principle of a basic electrodynamometer instrument is same as the PMMC instrument. The only difference in this case is that the permanent magnet is replaced with two fixed coils connected in series. The moving coil is also connected in series with the fixed coils. The two fixed coils are connected to electromagnets in such a manner that they form poles of opposite polarity. As the moving coil carries current through it and is being placed in the field of fixed coils, it experience a force due to which the moving coil rotates. The direction of this force is independent of the supply voltage as the current flowing through fixed coils and moving coil is one and the same. If the direction of current changes in the moving coil, then the field direction also changes, thus making the torque unidirectional.
There are ways to tell if it's not working, and that is if you drive on a rainy or damp day, it may stop working. A good way to test the coil is in a dark room or at night, spray water on the coil. If it sparks, it needs replacing.
What? whenever a magnetic flux linked with the coil changes an emf induce in the circuit..