Want this question answered?
That measurement is stamped on the rotor.
According to the 2000 Ford Windstar Owner Guide : The front park / turn lamps take the ( 3157 NAK , amber bulb )
The ABS sensor is located in the front brake set up. It is accessible by removing the tire and the caliper bolt, caliper, and rotor. It will be a black plug connected to a wire sitting on the top.
There are 2 wiper motors on a Windstar: 1 for the front wipers and 1 for the rear.
If you pull one of the front wheels the minimum thickness should be stamped or molded into the brake rotor near the hub area. I own a 2000 CR-V and the minimum thickness on mine shows as 18 millimeters.
You can't - well, you can.. but the front bumper cover and the grill are all one piece
firewall 1-----2-----3 4-----5-----6 front of Ford Windstar
the front or rear seal on the timing chain side
For our 2000 ford windstar it's $210 for all four.
On a 2000 Ford Windstar , 3.8 liter V6 engine : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
where is the tcm in a windstar 2000 located
Remove wheel Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub