most don't have a torque spec, just tighten till you cannot tighten anymore. -
Seperate answer different person, I would not recommend this. Torque specs are there for a reason and if you go to far you'll sheer the top of the bolts of or weaken them to the point when you actuate the clutch, bolt heads will sheer of inside the clutch housing your clutch will let go and you'll have metal flying around the bottom end of the motor - not good. The best thing you can do is, if you can't find the answer online contact a dealer or trusted ATV service center. If you have a torque wrench gradually increase the torque factor on it when trying to take the bolts of and when it clicks and your the bolt moves reduce by 1 and you have a pretty close spec. A close guideline but not scripture 100cc 5 -6 ft lbs 250 6-8 above that I don't know. I'm not a mech but I service my own equipment.
Yamaha Blaster Inner Clutch Spring Torque(5 Bolts with Springs) 4.3Ft-Lb. (51.6In-Lb.) Also, Center Bolt 5.1Ft-Lb. (61.2In-Lb.)
what is the torque for the bolts on the clutch springs for a trx 90/>
the clutch springs are not adjustable. proper tension is set when the springs are tightened all the way down. the bolts are 6mm w/10mm heads should torque to 90 to 110 inch lbs.
there should be 6 clutch plates
Does it have gear lube in the case? If so you will need to inspect clutch basket may need new clutch or clutch springs may have failed
The torque converter clutch is inside the torque converter.The torque converter clutch is inside the torque converter.
diaphragam clutch is small in size as compare to spring clutch and it transmits more torque as diaphragm exerts more force as copare to springs...... therefore it is advantageous to use diaphragm...
The cushion spring plays an important role in an automotive dry-clutch system. It strongly influences the clutch torque transmission from the engine to the driveline through its non-linear load–deflection curve
In semi centrifugal clutches,the springs are used at lower speed for torque transmission and the centrifugal force is used at high speed torque transmission. BY: Yogesh Phopale,BE(Mech)Solapur.
Between the two clutch facings
20 foot pounds for the head of a Yamaha blaster
A Yamaha Blaster not going into gear is typically a sign of an issue with the clutch. To troubleshoot, try to adjust the clutch at the lever. If this doesn't solve the problem, the shot clutch pack may need to be replaced.