What is wrong on a 96 Chevy pickup when brake lights stay on when driving but when you push on the brakes the lights come off?
I would first check your brake light switch which is attached to your brake pedal under the dash. Since you can turn off the lights by pushing the pedal it is possible the switch is bad. They are around $10.00.I hope this helps you. Mark
You can't adjust disc brakes Read More
How do I release the frozen brakes on the drum of a 1965 Chevy 3/4 ton pickup Read More
Yes it does, I have one! Read More
In a manual for that vehicle. Read More
If the vehicle is equipped with a trailer light plug, the wires for the brake lights and the turn signals have been connected together, which is common, as many trailers do not have separate lights for brakes and turn signals. Read More
same way you would on any other vehicle Read More
I have a 1996 Chevy Silverado that I want to turn the driving lights off. How do I do that? Thank you Read More
There are a variety of issues that can cause the tail lights to stop working in a 1993 Chevy S-10 pickup. There may be a blown fuse, a damaged wire, or the bulbs may be burned out. Read More
i need rear break digram for my Chevy 1500 k pick up where can i find it. Read More
go to the library and copy instructions from a manual Read More
3/8 inch Allen wrench. Read More
are brake lights staying on or is brake in the dash on ? Read More
old lights, blowen fuse, shorted wire? Read More
Not bled properly or not adjusted properly. Read More
1977 Chevy pickup brake lights not wordking but turn, tail,reverse allworks Read More
Hey Mitch ==Probably a bad ground on the lights. Check it out. GoodluckJoe Read More
i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs Read More
You may have a blown fuse or a defective brake light switch. Read More
Check the bulbs first, then the dimmer switch and wiring. Read More
Check the fuse, check the bulbs, then check the brake light switch. Read More
In the 1993 Chevy Caprice there is a brake sender located inside the steering column where the brake pedal is attached. Perhaps the brake lights are not working because of this, when a person hits the brakes. There could also be a fuse blown or a broken or shorted wire. Read More
Someone may have switched the sockets in the back of the lenses. Read More
there is a switch either under the shifter or on the side of the trans that activates the lights when you put it in R. It needs adjustment or replacement Read More
Front wheel squeaks while driving When you press on the brakes you feel grinding Could it be the bearings It is a 2004 Chevy Monte Carlo?
Sounds like you need brakes. Have it looked at soon! Or maybe the fact its a Chevy that might be the problem Read More
It may be time for a tune up. Read More
Could be a plugged up fuel filter. Read More
How do you change brakes on 2003 Silverado Pick Up? Read More
The dash lights on a Chevy Impala is used to illuminate it during night time driving. There are a series of bulbs spread out throughout the dash to light up all areas. Read More
NO it will not. Read More
What causes a squeaking sound when driving sounds like its coming from around the left front tire area 84 Chevy impala?
You may need to check your brakes or the rollers on your brakes Read More
How Do you Troubleshoot nonworking driving and fog lights in a 2002 Chevy Tahoe after already replacing the bulbs?
There is a fuse that runs fog and day lights, check it. Read More
I've got a better question, why is this question in the Chevy venture forum ? Read More
it might not have enough brake fluid or your ABS is going bad. i would take it to a shop cause that can be serious. Read More
sledge hammer last I knew the master cylinder was for the brakes, but the above answer may be adequate for that question. Read More
Is it normal for your 1991 Chevy 4x4 pickup to shift from park to drive without applying the brakes?
You did not have to apply the brake on a 91 model to shift it. There's nothing wrong. Read More
No brake lights but turn signals work? Turn signal switch brakes route through it. Read More
Why is your 87 Chevy pickup 350motor 350 automatic tranny not really goin into gear and feels like it holding back?
Check your brakes, sounds like they are stuck on. If the brakes are ok the problem is in the transmission. Possibly the convertor or the front pump. Read More
what is the wheelbase of a 1953 chevy pickup width and length? Read More
No. Read More
Yes they do. Read More
if timing belt brakes while driving,will it damage motor. Read More
Chevy s10 pickup headlights and tail lights do not work but brake lights do and head lights work when hit relay switch.?
its just a fuse, look for a fuse panel there are two. one under the dash and the other under the hood. Read More
If the warning lights come on when you start the car, but then go back off, there is no reason for alarm. However, if the lights stay on, or come on when you are driving you should probably stop driving as soon as you can and take the car to the mechanic. Read More
Could be spark in the motor, or the distributor and rotor need to be replaced. Read More
Yes it will Read More
YES there the same. Read More
check the fuse's first. then check the lamps [bulbs]..... Read More
check the multi function switch. I hava a 96 Chevy Monte Carlo and I had the same problem . I changed the multi function switch and the brakes lights now work. the rear brake lights run thru the switch on the turn signal circuit. try it and see. Read More