Want this question answered?
Kirchoff's Current Law: The signed sum of the currents entering a node is zero. Assume the top of the battery is a node. The current entering it (from the battery) is equal to the sum of the currents leaving it (to the branches). This adds up to zero.
Zero volts produces zero current.
You have to imagine the internal resistance as being in parallel with any load you connect. You get the maximum possible current when the load is zero. In this case, just apply Ohm's Law. That is, divide the voltage by the internal resistance.
zero-terminated string
No current flows when the the voltage is zero.
Bad IGBT in the inverter
Kirchoff's Current Law: The signed sum of the currents entering a node is zero. Assume the top of the battery is a node. The current entering it (from the battery) is equal to the sum of the currents leaving it (to the branches). This adds up to zero.
Zero
A: A current source can be defined as a zero impedance source. A battery is essentially a zero impedance since it can provide lots of current with zero volts out
You could put a know resistive load on the battery and then monitor the voltage across the load until the battery was at zero volts. Using Ohm's Law you can calculate the current at any time. Current = Voltage / Resistance. You can multiply the average current times the number of hours for the battery to go to zero.
Kirchoff's Current Law: The signed sum of the currents entering a node is equal to zero. This means that the current leaving the battery is equal to the sum of the currents in the branches of the circuit.
Ripple voltage, in the presence of a filter capacitor, is inversely proportional to load resistance. If the load were zero (resistance infinite), then there would be no ripple voltage. As the load increases (resistance decreases), the ripple voltage increases. The ripple waveform will appear to be sawtooth, with the rising edge following the input AC from the diode's conductioin cycle, and with the falling edge either being linear or logarithmic, depending on load. If the load is resistive, without a regulator, the falling edge will be logarithmic. If the load is constant current, such as with a regulator, the falling edge will be linear.
Character zero (the byte with the decimal value zero) is sometimes used to end a string. But in other cases, the size of the string is stored at the beginning of the string, and there is no end-of-string character. This allows any character to be included in the string.
By dividing the cell's voltage by the resistance of the circuit. This is specified by ohm's law: I=E/R. ANSWER a cell means battery which is a pretty good current source so the voltage can be near virtual zero and the current can be to whatever the impedance of the battery is at the time.
Zero volts produces zero current.
string is group of characters last value is initialised by zero
it is a current which has zero drift and it is ugly