0
What kind of bit should be used to drill a hole through a stucco wall?
Wiki User
∙ 12y ago
A Masonry bit will work.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Can you drill a hole through a diamond?
Yes
How do you hang a picture on stuco?
Carefully. lol Drill a small hole, then use a picture hanger. Make sure the hole is just slightly smaller than the nail for the picture hanger. Don't skip on drilling the hole, or you will crack the plaster/stucco. (I assume you meant plaster/lathe instead of stucco; stucco is outside of the house and is usually made from portland cement, plaster/lathe is used inside in older houses and is... well... plaster.)
What is the definition of a bore?
To make a hole in or through, with or as if with a drill.
What size drill bit should you use to drill a hole that is threaded for a 1by4-20 UNC bolt?
Your meaning is not clear. - If you are going to tap the threads in, use a 7/32 drill bit. If you want a hole that this bolt will slip through, use a 9/32 drill bit.
Can I drill a hole in glass?
Yes, but not with the usual drill bit. Drilling a hole in glass is accomplished with an abrasive that actually wears a hole through the glass.
How do you run cables through wall studs?
Drill a hole through the board
How do you run a wire through the firewall of a 2002 Chevrolet Silverado pickup for fog lights?
There should be a location where you can go through the firewall where other wires are already there. Piggy back on that hole. If not then just drill a hole through the firewall, being very careful not to drill into any wiring or components. Insert a rubber grommet in the hole to protect the wire, and then the wire.
Should you drill a hole in your car muffler so the water will drain from it?
No, Do not drill a hole in your muffler! The water evaporate when the car gets warmed up. If you drill a hole in your muffler, The next time it gets inspected it will fail.
How do you cut or drill through a fixed wall mirror to mount a light fixture?
i think you should drill through the wall slowly The question was about drilling an hole in a mirror. I think the correct way to do this is to mark out where the hole is required, get some putty and form a cupped mound below, fill with varsol or white spirit, and drill the hole slowly with a special glass drill bit. You must keep the bit lubricated with the liquid to dissipate heat and prevent the mirror from cracking.
How do you modify a Nerf shell?
You will either need a hammer and a nail or a drill, for the drill find the small hole in the back and drill through it until you can see through it. For the hammer put the nail in the hole in the back and keep hammering the nail until the orange stick comes out.
What tool will be used drilling hole in plasterboard to fit a 15mm copper pipe through?
15mm drill bit and a drill.
How do you drill a hole through a small rock?
In a bowl of water use a diamond tip drill and cover the stone with water. you need to use the drill with very little pressure and drill half way then drill from other side to keep from breaking out the sufface of the hole. The drill RPM needs to be at least 10,000 - 15,000 RPM.
