0
What kind of tools do you need to replace the starter on a 1996 Jeep Cherokee Sport?
Wiki User
∙ 19y ago
Just regular standard/metric handtools. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Wiki User
∙ 19y ago
Add your answer:
Earn +20 pts
How do you change exhaust gasket on 96 jeep Cherokee sport?
with tools.
What tools do you need to replace the starter on a 1989 Oldsmobile 98?
starter on this car should be simple 12pt metric socket and wrench set range from 10mm- 19mm and a pair of jackstands or ramps
What type of weapons and tools did the Cherokee use?
Why did the Cherokee Indians use bones and rocks
How difficult is it to replace the front hub bearing on a 1999 Cherokee sport you would like to know any issues as you are planning on doing it this week or next?
1 hours time if you have the tools 36mm socket 13 mm 12 point socket hammer penatrating lube most important
Where is the starter located on the 1994 Chrysler LHS 3.5 ltr. and does it require special tools to replace it?
It is on the left side of the block, only tools required are 13 and 15 mm sockets and wrenches.
What does the starter on a Chevrolet Cobalt look like?
The starter motor is behind the crank pulley on the passenger side. This is not a driveway job. You'll need a lift and a few special tools if you're trying to replace it your self.
What tools and weapons did Cherokee Indian's have?
buts
Tools To Replace 1994 Mitsubishi Mighty Max Starter?
Socket wrench and 14mm sockets. Should take off all the bolts it worked for my 1990.
What tools did the Cherokee use for agriculture?
because they were gay
What tools do you need to remove a starter for 94 Oldsmobile achieva?
Common hand tools.
What is the Rattling coming from when inline six engine is turned on in a a jeep 93 Cherokee sport?
I have a 1995 sport. the noise you are talking about could be either your Idler or water pump. Very easy to fix if your handy with tools. If its the water pump it may take about 4 hours, but just take your time.
How do you replace the starter on a 1998 Oldsmobile Bravada?
Simple! 1. disconnect the battery 2. Crawl under vehicle and remove two 14mm bolts holding starter. 3. Remover signal wire from solenoid 4. Remove main power wire 5. Bring new starter under vehicle with you 6. Replace signal wire 7. Replace power wire 8. put starter into hole. 9. Tighten two 14 mm bolts that hold starter 10. Attach battery 11. Set clock on radio 12. Clean tools 13. Bandage cuts on knuckles Piece of cake!
