Quantcast
answersLogoWhite
notificationBell

Top Answer
User Avatar
Wiki User
Answered 2004-09-21 19:27:03

Does the blower run? Runs only on high?

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Still Have Questions?

Related Questions

Where is the blower motor for a 2005 buick lesabre located?

The 2005 Lesabre has the blower motor mounted under the dash. It is under the glove box on the firewall behind a panel.


2003 buick lesabre blower motor?

The blower motor on a 2003 Buick LeSabre is used to circulate air inside the vehicle's cabin. It is also pulls in warm air from the heater core.


What is the difference between a BLOWER and COMPRESSOR?

There is no difference. A blower is just a term used for a supercharger. A compressor is any machine that compresses a gas for many different purposes. A supercharger in its many forms is a type of compressor


Where is the blower resistor on a 1992 Buick Lesabre?

blower resistor is behind fusesand realays under hood bolted into air duct



What are the ac parts in a car?

For the most part under the hood parts include the condenser, reciever/drier, compressor pump, compressor clutch, orfice tube/expansion valve, high and low cut-out switches and hoses. The blower motor, controls and evaporator are located inside the vehicle behind the dash.


Where is the condenser fan relay for a 2002 Kia Sportage?

The Condenser Fan Relay and the A/C Cut Relay on a Kia Sportage are located together under the dashboard on the passenger side of the vehicle. They are just aft of the heater blower motor. The Comndenser Fan Relay is the 20amp relay and the A/C Cut (compressor) relay is the 52amp relay.


How can I replace the blower motor in my c230 compressor Mercedes Benz?

To replace the blower motor on a C230 compressor of a Mercedes Benz, remove the bolts holding the motor in place. It is next to the blower, under the passenger side of the dashboard. Replace with new and reinstall the bolts.


Mitsubishi lancer resistor i replace my new resistor for may blower and after 4 days of used its keep burnout?

The Lancer blower motor's are known to heat up and burn out. If you remove it, it is labeled with "Do Not Repair", but it is possible. If you look inside of the block, you will see a flap sticking up - that needs to be soldered down in order to work in the 1 - 3 positions. I did it today, and it is a cheaper fix - Lasts longer too Thanks so much for prompting me to fix this before ordering new! Worked great! Another symptom you might find is that your AC/Compressor and condenser fan won't work in #4 position,but blower motor working fine.In positions 1-3 AC/Compressor and condenser fan work great,but no blower motor.This part of the equation was baffling me but the blower resister was the culprit. And solved the problem. Thannks


Blower fan only runs in high position for a 1989 Buick Lesabre?

Either the blower motor fan switch is bad or the blower motor resistor pack is defective. It is more than likely the blower motor resistor pack.


With the ignition switch key on why does the blower motor of my 90 Buick Lesabre make a clicking sound even when the blower is off?

Sometimes the blower is always on, at a low speed. If you have a system that turns off the blower completely, then you should hear nothing.


Will a Buick Regal have interchangeable parts for a Buick LeSabre?

I need a blower motor and blower motor resistor for a 1999 lasabre will the regal have the same part?


Why would our 97 lesabre blower work sometimes and sometimes not?

If the blower motor randomly and intermittenly quits and does not work, chances are good the blower motor itself is faulty, if the blower motor does not work on all fan speeds from low through high, it most likely needs a blower motor resistor.


How do you diagnose a heater blower motor problem on a 2001 grand prix?

If the blower only works on high the blower resistor is most likely the problem and should be replaced. On rare occasions if the car has blown the resistor more than once the blower motor shouuld be replaced.


Where is the Blower Control Module located on a 1997 Buick LeSabre?

I think under the hood covered with shroud on the firewall.




Does the air handler have to be replaced if you are replacing the same size condenser?

Hi: Good question, And often I do not. But fact is, I have a lot of years at this and info. ( answer ) Sure , if your salesman says its a match, and your indoor blower system and coild is a match,,, go for it. Hope this helps: Jimiwane


Why your ac compressor clutch and fan do not work?

The compressor clutch could be for a number of reasons. It could be a defective compressor clutch, it could be a bad low pressure sensor, it could be low refrigerant, it could be a frayed wire on the low pressure sensor. Your fan, assuming you're talking about the blower motor, bad blower motor, bad blower motor resistor, bad relay(s)... those are your culprits.


Why wont your blower run in your 96 gmc already replaced the relay?

Blower motor bad. Blower resistor bad. Switch bad. Fuse blown.


Where is the 2004 lesabre blower motor resistor?

blower motor resistor may be located in the blower motor housing, under dash on passenger side, motor brushes may be the issue rather than the resister, suggest check voltage to motor...


Why wont my Blower run on 1997 aurora?

Same problem on mine...I had the blower motor module replaced and it works great.



Where is the blower motor resistor on a 2004 buick lesabre?

blower motor resistor may be located in the blower motor housing, under dash on passenger side, motor brushes may be the issue rather than the resister, suggest check voltage to motor...


Where is the blower motor 'resistor' located on an 1997 Buick LeSabre?

You probbably have controler problems but the resistor is on the evaporator case.


Still have questions?

Trending Questions
How to Make Money Online? Asked By Wiki User
Best foods for weight loss? Asked By Wiki User
Unanswered Questions
How old is zak beggans? Asked By Wiki User
Does arsenio hall have ms? Asked By Wiki User