answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What motor did the 1994 ford bronco Eddie Bauer have?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Ford bronco 5.0 engine oil capacity?

I own A 1994 Ford Bronco Eddie Bauer with a 5.0 liter engine. The answer to your question is the oil capacity is exactly 6 quarts for an oil change.


Where is a 1994 ford bronco Eddie Bauer water pump located?

It is located on the front of the engine between the block and the radiator. You will see a few heater hoses run from it to a black piece on your passenger side. Also the water pump will have the main belt running around it


My gas gauge is not working on my 1994 Eddie Bauer Ford Explorer?

The gas gauge in the Eddie Bauer Explorer probably does not work due to a bad fuel sending unit. The sending unit is in the fuel tank in the same access area as the fuel pump.


What are the speaker sizes for a 1994 explorer?

Well I have a 1994 Eddie Bauer and I just had my back door speakers replaced and those were 6x8. I was also told that the front door speakers are the same.


What causes a ping and no accleration when the gas pedal is pressed fully while driving in a 4.0L 1994 Ford Explorer Eddie Bauer?

ur face


What is the fuel pressure required for 1994 Eddie Bauer Ford Explorer?

35 to 45 PSI , with the key on / engine off , according to my Haynes book


How can I get to rear window motor 1994 Bronco?

In the inside of the door there should be a piece of metal that unscrews. You just take it off a walah.


What is the amperage rating of an alternator on a 94 Ford Explorer?

According to motorcraft . com 95 amp for the 1994 Ford Explorer - XLT and Eddie bauer 130 amp for the 1994 Ford Explorer - Limited


Vacuum hose diagram for 1994 ford bronco?

vacuum hose dimgram for 1994 ford bronco


How do you change the power window motor on a 1994 ford explorer Eddie Bauer edition?

remove door panel. motor is held in place either with 3 bolts or rivets. one bolt/rivet is not accessible w/o drilling a hole in the door. look close and you see a dimple like a center punch dent. drill there. the rest is easy


When did Erhard Bauer die?

Erhard Bauer died on 1994-01-13.


Where is the OBD located on a 1994 ford explorer Eddie Bauer edition?

The EEC test fitting is in the engine compartment by the power distribution box - EEC IV / OBD I system (Helpfull)