Want this question answered?
Show video on
No. You don't want to float a synch box, either.
replace rear axle bearing
You have to remove the engine and gearbox. you will need a engine crane. Once you have the engine and box out, remove gearbox from engine and replace clutch, Refit gearbox to engine, put engine and gearbox back in car. Easy job if you have access to a engine crane.
To replace the axle on a 1993 Honda Civic the axle nut has to come off. The hub assembly also will need to be pulled back so the axle can be pulled from the transmission.
i need to know where the gearbox is for my Ford Expedition
Put the car on axle stands remove the lower engine cover, the drain plug for the gearbox is located at n/s/f at the bottom of the gearbox you will need a 8mm square key which you can buy many car parts stores for £3.remove the drain plug to drain the oil and clean the drain plug and put it back on after the oil is drained then remove the air box and remove the gearbox breather cap fill it up slowly and clean any spills on the gearbox as the oil will smell horrrible. the Peugeot 407 will take 2.6l of gearbox oil which you can buy from many car parts stores for around £17 job done. hope this may help
when gearbox fault light comes on, it means there is a problem with the gearbox. you need to take vehicle to a mechanic
manual for gearbox for trition 1998
you probably need a pair of snap ring pliers
On the gearbox to the right hand side when looking from the front. To the back of the gearbox. Unplug wire and use 10mm spanner to undo. There is an o-ring so you need to pull a bit hard to get it out.
bypass key on a trooper