an increase in security installations across the board, from schools, hospitals, small businesses, and corporate and industrial facilities, as well as residential installations
sir, i want to know about maximum demand controller, to control electricity maximum demand is required for industries to avoid any penalty, thanks.
peak is when the demand of electric power is very high, and off peak is when the demand is low
In an apartment building power is used to keep the building hallway lights and plugs operational. Run ventilation systems, heating. Anything that the building needs in the way of electrical services that is not associated with the apartments. This way the apartment owners are not paying for power being used by the building. This building demand load is known as the house load.
Demand charges are related to the maximum kW drawn during a particular time window, typically 15 or 30 minutes. The single largest window sets the demand charge for the month. While the average kW may be much lower, the utilities must install transmission and distribution systems to handle the much higher peak kW drawn during certain periods. The demand charge is supposed to compensate the utility for the added cost of the larger lines, transformers, etc. needed to handle the peaks. Simply recording the maximum demand would mean that just starting a large electric motor could send your demand charge sky high (remember that some motors draw 7-10 times their running current on start up!), yet the momentary spike in current draw would not require a distribution system that was 10 times larger. On the other hand, say you used a 100kW motor for 50 minutes an hour. Your neighbor uses a 1000kW motor for 5 minutes an hour. You both consumed the exact same kWh, yet the utility would have to install a distribution system that was 10 times larger to serve your neighbor. That is the type of consumption a cumulative demand window is designed to capture. Your neighbor would be paying for the extra cost involved in the 1000kW distribution system, even though he only needs it for 5 minutes an hour. Demand charges are an excellent incentive to do load leveling, or so-called peak shaving, and a huge industry has grown out of that reason. Cumulative demand is the addition of each billing period [average over the window] maximum demand as described above. This value can be used to assure that no reset of billing period data has been missed - no missing billing periods. The utility can use the cumulative demand collected with the previous billing, and add to that the current billing period's max. Dmd., and the result should be the meter's current maximum demand. If the values do not match, a maximum demand for some billing period has not been collected correctly. If someone broke the seal on the meter, and caused the meter to start a new billing period to attempt to avoid paying for an earlier maximum demand, it would be detected.
That depends on it's gauge, the lower the gauge the higher load it can handle.Another AnswerMaximum demand describes the maximum electrical load applied to a high-voltage (high-tension) electrical cable.
The second change was an increased demand for services. The growth in demand for services--and resulting production--continues to increase at a faster rate than the demand for manufactured goods.
Business Development Services are designed to support businesses in growth and every day management. Business Development Services may cover all areas of a business and companies specialising in this are usually in demand.
the cotton gin
The Cotton Gin
the cotton gin
By increasing government spending, you increase the demand for certain products because the government is looking to buy those products. The government can act as a consumer, and when a consumer spends more, the demand for goods and services is increased.
the machine thAT increased the demand for slaves was the cotton gin
firm and households have less money to spend . this leads to a fall in demand for goods and services. Clover
Demand Planning can be used for the development of a forecast that reflects known constraints and any possible associated impacts that may occur as a result.
When an economist says that the demand for a product has increased this means that
Growing families increased the demand for products.
firm and household have less money to spend this heads to a fall in demand for goods and services.