Want this question answered?
The total resistance in a series circuit is determined by adding (summing) the individual resistances of each component in the circuit.
If measuring resistance of materials or resistors by themselves(not soldered into a circuit board) resistance is constant. If measuring resistance of a circuit then it could fluctuate with the components functioning in the circuit.
On Circuit Resistance = Close to the total load Resistance. Off Circuit Resistance = Near Infinitive High Resistance.
What is the Relationship between resistance and inductance in a RL circuit?
If you add a second resistor, the resistance of series circuit will increase.
a circuit with no resistance or zero resistance can be considered as open circuit in which the current is zero. without resistance the circuit just becomes open ()
For the circuit to get cold it must include a reversed junction thermocouple like in an electrical thermocooler.
No, the resistance in a circuit does not change when voltage changes. Resistance is an inherent property of the circuit.
The total resistance in a series circuit is determined by adding (summing) the individual resistances of each component in the circuit.
Since when did post boxes include a balanced bridge resistance meter? Or become the "X" resistor in a circuit of any kind.
Not sure what you mean. The equivalent (total) resistance in a parallel circuit is less than any individual resistance.
If measuring resistance of materials or resistors by themselves(not soldered into a circuit board) resistance is constant. If measuring resistance of a circuit then it could fluctuate with the components functioning in the circuit.
On Circuit Resistance = Close to the total load Resistance. Off Circuit Resistance = Near Infinitive High Resistance.
Voltage = (current) x (resistance) Current = (voltage)/(resistance) Resistance = (voltage)/(current)
You would have to specify the circuit.
Continuity is checking for a completed circuit including a short circuit. Checking resistance would be checking in ohms resistance of a circuit, motor windings or an open circuit.
Resistance is generally used to control the flow of amount of current in the circuit.