answersLogoWhite

0


Best Answer

Got the same issue, gas cutting off on hills. Does anyone have some good instructions on how to replace the fuel pump on a 1998 Mercury Villager 3.0 L? Thanks... HJC

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What should it cost to replace the fuel pump on a 1998 Mercury Villager?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can a 1998 mercury villager transmition pan fit on a 2000 mercury villager?

It should be the same.


Should one purchase a 1998 mercury Villager if speed sensor is needed?

The speed sensor is not expensive and is easy to replace.


How do you replace the odometer cable on 1998 Mercury Villager?

You don't as it does not have a cable. You replace the speed sensor instead.


How do you replace the fuel pump on a 1998 mercury villager?

The fuel pump is in the tank and the tank must be removed to replace it.


How long does it take to replace the rack on a 1998 mercury villager?

With the right equipment, a couple hours.


How do you replace light bulb on high mount brake light on 1998 Mercury Villager GS?

Just unscrew it.


What is the oil weight goes in a 1998 mercury villager?

According to the 1998 Mercury Villager Owner Guide ( 5W-30 ) is the preferred oil


How do you replace a side window in sliding door of a mercury villager 1998?

If it's the opening type, unscrew the latches and take it off.


How do you replace headlight assembly on a 1998 mercury villager?

The headlight assembly is only held on by a couple screws and can be replaced in a couple minutes.


What kind of oil in 1998 Mercury Villager?

10w30


Does the 1998 Mercury Villager Van LS V6 have a timing belt or timing chain?

The 3.0 litre V6 engine in a 1998 Mercury Villager has a timing BELT


How do you change a CV Axle on a 1998 Mercury Villager?

To change a CV Axle on a 1998 Mercury Villager, take off the front tire and the caliper assembly. Take off the pad and the rotor. Disconnect the steering knuckle and pull the CV axle off. Replace with new and reinstall the parts.