Were and how do you change a brake light switch on a Daewoo Leganza 2001
Disconnect battery and leave for about 10 min. Then reconnect. The check engine light went away on mine.
it goes under the brake pedal, it should twist out , it has two tabs on it , only about a half turn
I just had my Daewoo Leganza brake light switch replaced. It goes under the brake pedal. and now my brake lights work fine.
needs put on a diagnostic scanner, that should put the light out
This either means that your emergency brake (hand brake) is on, the light switch needs to be fixed, OR (most common) you need to add more brake fluid. Always check your brake fluid first!
Which light? Is it the dome light? the headlights? the little annoying blinking one next to the radio? I might be able to help.
Auto Zone part #80171.
Hope this will help it happend to me. It was my cam sensor and the dealer fixed it for free.
there should be a reset button in the clove box but if there is not one put your key to acc and then push your adometer until you see the light does not flicker any more
Have vehicle scanned to determine the problem
Check your alternator, Mine did the exact thing. The Battery light and the !!BRAKE!! Light came on and couldn'y figure it out for the hell of me, did volt tests while running and only had 12.5 volts on the battery. I changed the alternator ($179.99) and got back to the normal 14 or so volts while running and lights shut off. no idea why the brake light was on at all.
there are various methods, 1)- remove battery connection for 20 mins and reconnect -it might go ( remove overnight if it didnot go) 2)-go to autozone and ask then to check -they have a instrument that can tell you what the fault is,but they donot reset that code, so light still stays. but find some onewith that instrument or buy one for 50$ and reset and the light goes off
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
If the bulbs are good, check your stop light switch.
3 very quick and obvious things that will tell you the TPS is operating correctly. 1) If no signal is being received, the transmission will stay in 3rd gear and will not shift. 2) If high voltage exist, the transmission will shift very late if at all but will take of in 1st gear. 3) The check engine light will be on.
depends.firstly you need to have the system read with a scan tool to interpret codes,could be anything from wheel speed sensors to broken teeth on ring gear or abs unit itself.
12.4 gallons and your light should come on at 1.5 gallons
Get the used engine! The engine is an "interferance type", damage to valve train when the belt brakes.
Check your owners manual. There should be a description/picture of the check engine light.
check oil pressure with a gauge possible bad pump or engine is tired
Light should come on for 4 secs and then go off. If it stays on or doesn't come on at all then you have a problem.
Check under the dash along the back side of the brake pedal arm, the brake light switch is mounted there. Some tomes it comes loose from the mounting and the adjustment is off and the arm does not make contact with the switch. This happened to mine.
Yes unless the code is for something completely specific to the manufacturer. Such as a computer failure. Then you will require assistance from the dealership in the reprogramming of the computer. So 9.5 times out of 10 then the answer is yes. Good luck. Answer The check engine light can be cleared by disconecting the battery for 30 seconds. If when the battery is reconected and the car is driven, the check light comes on again there is a fault that should be investigated.
It should come on for a three second bulb check and then go out.