These bolts are 12mm x 1.75 thread pitch. Im unsure of the length. I use 2.5 inch length for putting these engines on a engine stand
The mass air flow sensor is located in the throttle body housing on the 3800 engine. There should be 4 screws that hold it down to the housing. Once they screws are removed, the sensor lifts off of the throttle body.
What year is the gtp, if 95 or newer yes, if gtp is in the 80's then no due to pollution restrictions today, and may have to change the computers from each vehicle. Each computer is set to specs for the engine it controls.
on the crank behind the front cover
Not very easily if at all, and why would you want to?
it's located on the firewall right in back of the intake
A haynes manual...
They always blow the head gaskets between 70 and 100 thousand miles.
3.8 litres is fractionally more than 1 US gallon.
The 3.8 engine is similar in all the grand prix 97 to 2003 Follow the top radiator hose to the top of the engine, the place it bolts up to should be your themostat. Remove the hose, take the bolts out (usually two) put the new one in with a new gasket and bolt it back together. For thermostat replacement step by step instructions with pics- http://www.pfyc.com/supportfiles/tstat/tstat.htm Hope this helps. "G"
You can safely put 2ml into the 10l aquarium
If you mean 3.8 Litre engine, the answer is 200 horsepower, from the factory. 225 lb/ft of torque.
there should be a sticker under the hood of the car that tells you what the gapping should be. .60