Well to the best of my knowledge bolts are not used to hold the rear drums onto the hub.The drums will be held on with normally Phillips head screws that are flat head style.You should spray some liquid wrench or bp blaster on them let sit for a few minutes before you try to remove them.I use a large handle Phillips screw driver with a pair of channel locks gripped onto the handle to give you leverage so that you do not strip the head of the screw.Once you remove the two screws you will then install the two screws into the threaded holes on the drum about 180* and run those into the drum equally.This pushes the drum off the hub and you may have to tap the drum with a hammer and use a flat head screw driver to pry the drum away from the backing plate.Make sure you have the parking brake released!And do one side at a time so,you install the new parts correctly and you will have the opposing side for reference if you are no fluent with this set up.
DOT 3 brake fluid
i have a b2200 Mazda 1993 and everytime i brake a clicking noise come out of the passenger side like in the back of the seat at the same time the brake pedal moves down with each click what can that be.
remove the wheel,remove the brake line,removing the two bolts holding it on and then install opposite of removing.
Torque specs for brake caliper bolts 2005 mazda 6
how do remove the brake drum on a 1991 mazda 323
remove brake drumremove bolts holding bearing to rear spindlebig hammer to knock it out of the spindleif no bolts then look for large clip around the hub bearing to remove
you need to take off both caliper bolts and remove the caliper from the carriage... most Mazda calipers will not pivot...
Remove caliper (possibly held by 14 or 17 mm bolts) then remove pads from caliper, press piston in and re-fit new pads.
Remove the intake tube and you'll see it under the throttle body. Its a pain to get to the two bolts holding it, you will have to feel your way around to get to the bolts. Unbolt it and remove it, when you remove it clean it with carb cleaner or brake cleaner and let it dry completely.
If they are of the "peel off" type Remove wheels Remove caliper mounting bolts Slide calipers off rotor Slide rotor off hub
nb,
Remove the high mount brake light retaining screws from your Mazda Protg. Remove the high mount brake light wiring harness. Reverse the process to install your new high-mount brake light.