0
10mm
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you remove alternator on 1998 Saturn ls?
open hood. take out bolts. hold in hand. unplug wires. all done
How do you remove the alternator from your 1998 Pontiac Grand Am GT?
On your alternator, there should be two bolts on either side of the alternator. Losen the surentine belt up enoungh to slide off the pully of the alternator. Remove the two bolts on both sides of the alternator and slide the alternator up.
How do you fix a broken serpentine belt pulley on a 1998 2.2liter Chevy cavalier?
remove the bolt on the pully or use a pully remover depending on the style of pully and put new one on.
How do you replace the water pump on a 1998 Nissan Gloria?
There is bolts unscrew them and the replace again
How do you replace a water pump on a 1998 Saturn?
Remove the Serpentine belt. Pull the bolts that hold the water pump in place (5 or 6, something like that). Then the water pump should pull out of the block. It may be held in place with some gasket sealer, so once you have the bolts out you can pull hard on the pump. Remove the pulley by turning the 3 bolts. Put it all back together in reverse order. You may need to remove a couple parts to get to the pump.
How do I replace the Water pump Belt tension pully mount 1998 Pontiac gran prix 3.8?
unbolt the old one bolt on the new one
Where is the water pump located on a 1998 Mazda Protege?
The water pump is under the timing belt cover. To access the water pump, you must first remove both belts, the water pump pully, and the timing belt cover.
How do you replace timing belt 1998 metro Lsi 4-cylinder?
remove plastic cover at inner fender , remove crank pully (6 bolts with 8 mm heads) remove t belt cover align t marks cam and crank they are obvious loosen tensiner remove belt install new check marks reassemble it is easier if you remove bolts from motor mount to lower motor to get pully off
How do you change the water pump on a 1998 Chevy Ventura?
The water pump is in a houseing connected to the upper radiator hose.It is best to have an air rachect wench because the belt pulley over it slips.Leave the belt tight then lossen the 4 bolts. Use a 3\8 socket wrench on the top of the belt tensioner,and push it back too loosen the belt and then take the belt off of the pump pulley. Now take the 4 bolts off the pully,the pump is under the pulley.You should have 5 10mm bolts to take off the pump ,then pry the pump away. Make sure you clean all the old gasket off.It took me awile to figeure out that I needed the air tool too loosen the bolts because the pully kept rolling ,Im a little slow.
How do you remove the power steering pump on a 1998 GMC Sierra 1500?
carefully with a special pully tool you can rent at most part stores. you have to remove the pulley to acess 3 bolts that hold the pump in place. I did it on a 95 1500
When did Viva Saturn end?
Viva Saturn ended in 1998.
When was Return of Saturn created?
Return of Saturn was created in 1998.
