7 mm Allen wrench
_________________________________________Front caliper bracket mounting bolt-148 ft-lb Front caliper guide pin bolt-74 ft-lb
9mm Hexbit Allen Socket. Hard to find. Sears usually carries, you can order online
What size Allen socket is needed to remove bolt from caliper on 2004 ford escape
caliper bolt size 2007 Honda odysey
A 3/8" Allen wrench will remove that bolt on the front caliper.
9mm Allen, hard to find. take 3/8 Allen and grind it down
If memory serves, 18mm. That would be the bracket bolt. The caliper bolt has a 9mm thread.
The Rear Caliper Bottom Bolt head size is 12 mm. The Top bolt is enclosed only making it a slide bolt therefore you cant and really have no need to remove it. So the only bolt you should remove is the bottom 12mm head bolt. Then there will be a 14mm bolt that will hold the Emergency Brake Cable Bracket to the Caliper. Loosen this bolt and remove the Emergency Brake Cable Bracket from the Caliper. Then pry the bottom of the caliper up off the disc. This will allow you to swing the caliper up then push the caliper back to slide the caliper off the enclosed bolt slide at the top of the caliper. This will allow access to the inside and outside pads to remove them and allow you to press and rotate the Piston (Push and Twist-in Pistons) back into the Caliper with the right Brake Caliper Compression tool. The rear two Caliper Bracket bolt head sizes are 18mm. You must remove the Caliper bracket in order to remove the rear brake disc. The Front Brake Caliper Bolt is a 3/8" Allen head bolt. There will be two bolts holding the front calipers to the Spindle. The Front calipers are standard push-in Pistons.
70
I have a 2003 Escape and it took a 7 mm socket.
9mm hex
Just remove the bolt that you can get to. You then rotate the caliper on the other bolt until it will clear the disc. You then just slide the caliper off of the other bolt.