Want this question answered?
9`16
The belt is a M74747 which is 1/2" x 105"
Most likely 1/2"
I read online on some forum that they are 8mmx25mm bolts and JD part number is 19m7867.
your thermostat is located on the engine where your lower rad hose goes in your engine two bolts hold the housing on . no gasket sealer is needed
Depends On What The Starter Is From. Car Model Engine Size, Or Mounting Bolts Ect. If It Is The Bolts That Assemble The Starter< You Can Get These At A Starter Alternator Shop. The Mounting Bolts. Drop By The Dealer Parts House They Can Fix You Up.
The upper engine mount is on the passenger side of the vehicle right in the middle of the engine. There are 5 bolts holding it on. The bolts are a size 15mm deep socket. Remove the two bolts on either side. Jack up the engine from the bottom, underneath the oil pan, using a piece of wood between the jack and pan. Now remove the 3 bolts holding the mount to the engine. Replace the mount. Screw 3 bolts back in. Lower the engine and screw the two side bolts back in.
Should be between 15mm or 18mm
Bell housing to engine block, 4 bolts are 3/8"-16 and 2 bolts are 7/16"-14.
What size engine? its usually where the upper hose meets the engine under an aluminum outlet held on by two bolts
Depends on engine size. usually a 10mm socket. to remove bolts or a #6hex key
Special bolts! Do not replace with generic will fit bolts! But the head size on my car is 18 MM