0
32mm or 1-1/4
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you replace the pinion seal on the rear end of a 1970 Chevelle?
Best left to a mechanic as the drive shaft has to come down and the big nut on the pinion gear that holds the drive shaft mount has to come off and then you can install the new pinion seal.
Are the front rotors on a 94 camaro pressed on?
no...just remove the dust cap...there a nut with a carter key remove the key.then the nut...and it will slide right off
Low oil pressure shut off on 1994 camaro?
What size engine?
Will wheels off a 1978 Camaro fit a 1984 Camaro?
if the bolt pattern is the same and bolt size yeah then it'll fit
How do you replaced and adjust your rear pinion bearing on your 1995 ford full size bronco?
chock wheels on vehicle u will need a good heavy duty air gun or a good solid socket with breaker bar now get under vehicle, remove rear U-Joint and lower drive shaft out of the way. next with a snug fitting socket remove the large nut , (pinion nut) that was hidden by the u-joint. then with a hammer knock the pinion yoke off remove bearing. replace with new bearing NOTE: check yoke for wear, you may need to use a speedy sleeve to repair damage. if it looks good you won't. replace yoke replace washer and pinion nut, (always use a new pinion nut) tighten to specified torque replace drive shaft and U-JOINT, (now is a good time to put new u-joint in while you have it apart) finished
What size is nut on front hub to take the roter?
What size is the nut on the front break system to take the rotor off. Of my 2002 Trailblazier LT 4.2l 4x4.
What is the Rear pinion nut torque on a 2001 ford ranger?
wish i can tell u but ur best bet is calling dealership directly or sometimes a part store will have it in the computer and yes dealership will usally try to get you to come in but be persisent that you will or can not and just want but off the top of my head i believe its 15 to 17 pounds of torque for the pinion nut srry couldn't be more helpful
How do you remove the rear axle of a 1984 Yamaha moto 4?
Remove Drive shaft from engine. Unbolt rear diff from the machine along with both wheels, brake cable/rod. Pull off the hubs and drum cover as well as the 2 spanner nuts. Unbolt the housing halves and slide the Brake side half off the shaft. U now need to get the appropriate size nut, drill out the center so it slides over the pinion shaft. Then use the portions of the nut that protrude out of the case to UNSCREW the pinion from the housing. Remove it and the axle will now separate form the housing..
How do you get a striped nut off the power steering mounting bracket?
Alot of people confuse stripped with rounded, is the nut rounded so that you cannot turn it with the proper size wrench or are the threads damaged so the nut spins but will not come off?
What size socket do you need to take the axle nut off on 95 dodge neon?
22mm
What size is your fuel tank 1991 camaro?
15 gallons but you can always top it off like at 17 max gals.
How do you change the heater hoses on a 1999 z28 camaro?
The 1999 Chevrolet Camaro heater hoses will have a swivel nut on each end of the hose. Turn the swivel nuts to the left and the heater hoses will come off. Reverse the process to install the new heater hoses.
