wish i can tell u but ur best bet is calling dealership directly or sometimes a part store will have it in the computer and yes dealership will usally try to get you to come in but be persisent that you will or can not and just want but off the top of my head i believe its 15 to 17 pounds of torque for the pinion nut srry couldn't be more helpful
What is the torque specs on a 2001 ford truck rear end pinion nut..
The General Motors 3.42 rear end pinion?ænut torque specification is 240 pounds. The pinion nut should be torqued in 80 pound intervals.
I don't believe there is a specific torque specification! Once you install the crush sleeve and tighten the nut to the desired preload on your pinion bearings, your torque will be what it will be.
210ft. lbs.
The rear wheel torque spec for a 2001 Dodge Neon is 160 foot pounds.
The only torque you should be concerned with is the torque it takes to rotate the pinion gear alone, 8-14 inch pounds for old bearings, 16-29 in/lbs. for new bearings. The torque it takes to crush the crush collar (tightening the pinion nut) will be above 140 foot lbs. and this will set your tension on the pinion bearings. If you put a new crush collar in you are going to have to remove axles and carrier to get the proper pre-load on the pinion bearings.
just got my 2004 ram done at the dealer for 83 bucks. worth the money and have them do it :)
It sounds like the pinion nut is not tight enough and the pinion is now moving in and out. This will do bad damage to ring and pinion. You will need to replace crush sleeve in rear end now.
need to find out what is the spindle nut torque specification for a 2001 KIA RIO
axle bearing or brakes or pinion bearing
Dana 35
Preload is the amount the pinion bearings are squeezed together by the pinion nut.