0
stock mustang 5.0L... 15/16" socket
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
When replacing water pump on 95 contour 2.0l engine harmonic balancer seems to be in way cant get it off how do you do this?
Pull the retaining nut then use a puller to remove the harmonic balancer.
What is the proper way to remove harmonic balancer on 92 jeep larado 4.0 motor?
harmonic balancer has threaded holes for attaching the proper puller.remove big nut from shaft then use whell puller
Can a harmonic puller also install a balancer?
Not that I know of. I use a piece of threaded rod that fits into the crank along with a few heavy duty flat washers and a nut to draw the balancer in.
How to remove the harmonic balancer on a 1999 5.7 vortec?
You need a socket to fit the holding nut and a large gear puller. Instructions are in the manual for the vehicle.
How do you change the crankshaft vibration damper on a 1993 Jeep Cherokee Sport?
do you mean the harmonic balancer...ok..to remove you need to remove the fan and shroud assembly. YOu may need to remove the radiator to get enough room to get a impact gun and a socket on the nut to remove the harmonic balancer if you dont have a impact you are going to have to lock the engine and get a large breaker bar and a socket on the nut and then remove the part.
How do you install a harmonic balancer on a small block Chevy engine?
Slide the balancer on the crankshaft snout as far as you can by hand, then put a harmonic balancer installation tool in and crank it down until it bottoms out. If you can't afford to buy the tool, you can make one with a piece of 1/2-20 threaded rod, a nut, and some big thick washers. Put grease between the washers so they will slip easily while you're tightening the nut.
How do you remove the harmonic balancer on a 94' Ford F150 5.0L 302?
I have not taken one off a 74 specifically but every one I have done required a Gear Puller. The puller will bolt to the Harmonic Balancer and the center bolt sets on the head of the Crank Shaft bolt. As you turn the center bolt in it will pull the balancer off.
What size puller is needed to pull centrifugal clutch on a 1999 Honda TRX 250 Recon?
you can use a harmonic balancer puller for a car to remove it no problem hardest part is removing the nut that holds it on it is left hand thread so righty loosy lefty tighty
Remove harmonic balancer on a vs commodore?
You Will Need Breaker Bar, 15/16 socket or metric equivalent, piece of pipe to increase length of breaker bar. Remove the fuel pump fuse Place socket on big bolt in the centre on Harmonic Balancer with the Bar and pipe on top on the passenger side chassis rail. Turn car over a few times, the nut should loosen. Remove Balancer with a claw puller or if you're lucky it may just wiggle off.
How do you remove steering wheel from Kenworth T 600?
You gotta pop the cover off with a screwdriver, remove the retaining nut, then you need to use a puller either specifically for steering wheels or a harmonic balancer puller to separate the steering wheel from the column.
How to set timing on 460 ford engine and what degree?
loosen the nut holding the distributer in place and turn the distributer clockwise or counter-clockwise. You will need a timng light to see the timing mark on the harmonic balancer. There will probably be complete instructions with the timing light.
Where is the stator located on a harley Davidson 88B motor?
It's in the Primary behind the Harmonic Balancer looking item, if I remember correctly the nut is 1 1/2".Hope This Helps.I think some early model 883's had the stator behind the clutch hub.
