Slide the balancer on the crankshaft snout as far as you can by hand, then put a harmonic balancer installation tool in and crank it down until it bottoms out.
If you can't afford to buy the tool, you can make one with a piece of 1/2-20 threaded rod, a nut, and some big thick washers. Put grease between the washers so they will slip easily while you're tightening the nut.
The engine has a harmonic balancer on it, but if it is off, it is easy to re-install. Simply line up the key and tap it on most of the way and torque down the center bolt.
At the front of the engine, to the driver's side of the harmonic balancer.
The front bottom PULLEY on the engine is bolted to the blancer.
YES it can, but the engine would vibrate and shake if it did.
Go to Autozone and tell them u need a harmonic balancer puller
it will be mounted at the harmonic balancer on the bottom and front of the engine
It is located on the left-hand side of the engine block near the harmonic balancer.
8 inch balancer.
It is behind the very BOTTOM pulley on the front of the engine. The big pulley.
Yes.
If you look at the harmonic balance you will see on the front of it a medium size circle. That will be your timing mark.
they make a harmonic balancer install/ remover....very simple with the right tool... more than likely any local parts store should have one on the shelf...they come with a decent diagram to help ya out