36
Yes it will and is fully operational but it looks slightly differant.
72.5+tighten to align cotter pin hole
No, not just bolt on and go, get the rear spacer from the gsxr wheel and install rear wheel with that spacer and remove te stock one that's on the Busa, then mill .125 off the rear brake caliper hanger so it tightens to the wheel.. as for the front you'll need the gsxr 1000 rotors too, as well as spacers from the gsxr for them to fit a Busa.
Stock between 145-155 rear wheel HP.
110nm
Disassembly
The torque spec is at 95 ft/lbs. Per cycle center of denton.
My 2001 durango slt plus 4x4 has 9.25 rear axle and 8.25 front
The rear wheel hub spindle nut (axle) size is 30mm. I just changed my rear wheel hubs today
A 2001 Dodge truck does not have a speedometer cable. The speed signal comes from the rear axle speed sensor. (the sensor on top of the center of the rear axle)
the 2003 gsxr 1000 has 157 to rear wheels at 10,850 rpm but what is so likeable about the 03 is add a pipe and filter and your already hoverinng 165 170 wheel h.p. trust me i have one pushing 187 rearwheel horse
The rear wheels are bolted to the axles. The axles run through the inside of the rear end housing.