It's either 14 or 17 mm wrench , not Allen key.
Which allen wrench to change brakes on mazda tribute 4wd 2005?
It is not Allen . It is a 14 mm open wrench
7 mm. You can buy this.
It would be a 14 or 17 mm wrench, not Allen key. Hardly any Asian cars use Allen keys.
The calipers need a 7 mm hex wrench. The Caliper holder to remove the rotors takes an 18mm socket. This is a 2003 Ford escape..apparently it's the same as a Mazda tribute.
There is a 14 mm bolt on back of caliper. Remove this & use a 4 mm Allen wrench to back piston into caliper.
This week, I have changed the brake pads on two vehicles that I have never worked on before. I jack them up and get in there with a full set of Allen keys and small wrenches within reach. I look and see if it needs an Allen key or wrench and approximately what size. Then I try tools that may fit till I find the correct one -usually within 2 tries. - This is not a complicated exercise. . . .
It will be a 14 or 17 mm wrench.
7mm Allen wrench
I think that is a 14 mm open wrench, not Allen.
oem is 75.6mm 14 flutes but 76mm wrench also fit it.
On the back of the caliper there should be a bolt its a 14mm you take it out and inside there is a bolt also its Allen key you use and Allen key and retract the caliper. it works on all 626 from 1994 till 2002