0
What size oxygen sensor socket wrench for 1997 ford expedition?
Wiki User
∙ 11y ago
If you are replacing the old sensors, you can cut off the wires at the sensor and slip a 7/8" box wrench over the sensor for removal. Use the open end 7/8" wrench to install the new one. Tighten the new sensor as you would a spark plug.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you remove the air fuel sensor in a 2002 Tacoma?
With a 7/8in. Oxygen sensor socket or wrench
How do you replace oxygen sensor in Honda Odyssey?
To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.
How do you replace the oxygen sensor on a 1999 Ford Expedition 4.6L?
LOCATE THE SENSOR IN QUESTION THEN WARM THE ENGINE SLIGHTLY TO MAKE REMOVAL OF THE 92 SENSOR EASIER THEN USING A 02 SOCKET OR 7/8 WRENCH LOOSEN THE 02 SENSOR AND REMOVE IT ALSO DISCONNECT THE WIRING CONNECTOR.
Where is the oxygen sensor located on a Buick rendezvous?
The oxygen sensor on a Buick Rendezvous is located immediately before the converter on the driver's side. You will need either a special socket or a wrench to remove the sensor.
How do you replace an oxygen sensor in a 1998 Dodge pickup?
You start by unplugging the electrical connector. You then use a 7/8 inch wrench or oxygen sensor socket to turn counter clockwise until removed. Reverse steps to install.You start by unplugging the electrical connector. You then use a 7/8 inch wrench or oxygen sensor socket to turn counter clockwise until removed. Reverse steps to install.
How do you change the oxygen sensors on a 2003 Ford Expedition?
use a 7/8 ring socket or line wrench or if all eles fails use a 7/8 snap on wrench
How do you replace oxygen sensor in Honda civic?
The oxygen sensor on a Honda Civic is replaced by disconnecting the wiring harness and removing the sensor using a socket wrench. Anti-seize paste is applied to the threads, a new sensor is torqued into place, and the wires reconnected.
Where is the bank 1 sensor 2 oxygen sensor on a 1997 Chevy S-10 2.2?
bank #1 sensor #2 is the oxygen sensor that is past the catalytic convertor(some mechanics call it the downstream sensor)the sensor is located between the convertor and muffler you can use a 7/8 wrench or a oxygen sensor socket if you have one
How do change the oxygen sensor in a 1998 Chevy lumina?
Either a O2 socket & ratchet or a 22mm wrench. Best find out which sensor first as you could spend lots of money guessing
How do you change the oxygen sensor in 1998 Pontiac transport?
you will need a special 02 socket for the one in the manifold and you can use a 7/8 wrench on the one after the converter.
How do you change an oxygen sensor in a 2001 Volkswagen Jetta?
You need to purchase the tool for removing the O2 sensor. It's a socket that has a slit down the side for the O2 sensor cable. This will cost you about 20-30$. The 02 sensor will un-screw with a socket wrench. Best done when car is cold. Otherwise you will burn your hands. Good luck.
Where is the oxygen sensor on a 1999 Jeep Wrangler how can a new one be installed?
oxygen sensor is located on the exhaust coming from the manifold.might have 2 . one on each side. to install a new one , unplug the wire and use a wrench or a special socket to remove or take it to a shop
