0
That's a pretty big drill bit, -it drills a hole just a tad larger than 3 3/8 inch wide.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What size drill bit for 5-16 lag screw?
I use 1/4 drill bit for a 5/16 lag screw in most materials.
What size drill bit should you use for a hole to be tapped for a .25 x 20 screw?
I use a 3/16 drill bit for that.
What drill bit to use with different size screws?
If they are self tapping screws, the drill bit is as thick as the solid barrel of the screw. If you want the screw to go through easily to have a nut on the other side, then the drill bit is slightly larger than thread size.
What size pilot hole do you drill before using the countersink bit in stainless steel?
I drill a pilot hole the size of the 'barrel' of the screw. -I always use a combination drill bit for sinking screwheads. The first part of the bit is the diameter of the 'barrel' of the screw and the step, one inch higher is the size of that screw's head. (The barrel is the diameter inside threads) -I have a set of these drill bits for #6, #8, and #10 screws and they are great.
What size hole needs to be drilled for a number 6 screw?
#4 Screw use a 1/16" Drill #6 Screw use a 3/32" Drill #8 Screw use a 1/8" Drill #10 Screw use a 9/64" Drill #12 Screw use a 11/64" Drill #14 Screw use a 3/16" Drill
How do you remove a bored out screw?
Use appropriate sized drill bit to drill completely through the stuck screw and retap the hole if new screw is necessary.
What wood drill bit size would I use for one quarter inch diameter lag screw into 2 pieces 1 AND HALF inch width wood board?
A 3/16 drill bit.
What size drill bit for 10 metal screw?
It really depends on the material you are drilling. Thinner material will use a smaller pre-drill bit. Try drilling a sample hole on a piece of scrap or where it will not be visible Then try your screw. Adjust your hole size if necessary
What size drillbit do you use in inches for a 16mm drill bit?
I would use a 5/8 drill bit which is almost exactly 16mm.
What size drill bit for 8 gauge screw?
0.31 inchANS 2 - or, in fractions, 5/16 ths
What drill bit you use for a 0.875 hole?
You use a 0.875 bit or a 7/8 bit . They are the same size.
What size drill bit is mm?
4.5 mm is close enough to 3/16 to use that if you don't have a 4.5 drill bit
