0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the crank shaft sensor on a 92 Mazda mx-3?
To the right of the crank shaft pulley. You should see a single black wire going up from the pulley. All you need is a 10MM socket to remove it.
How do you remove crank shaft pulley megane?
To remove a crank shaft pulley you need to first jack up the car. Next, remove the bold holding the crack shaft pulley in place and remove the unit. Reverse direction to put the new crank shaft pulley on your car.
What tool do you need to remove a crank shaft pulley?
12mm /19mm
Where exactly is the 2000 Chevy Impala crank shaft sensor?
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
Do you need a Crank Shaft Head to put on a Crank Shaft in Lacrosse?
I would recommend that you do put a crank shaft head on a crank shaft. Putting any other type of head on a crank shaft could possibly break the head.
Remove crank shaft bolt Ford Escort?
you get a gun and you shot it till its removed
How do you change the crank shaft position sensor on an Oldsmobile Intrigue?
For 3.5l, remove starter.
What would cause a crank seal to leak on a 1990 Mitsubishi montero ls 3.0 liter v6 engine?
AnswerCheck the crank pully bolt. If it has come loose you will have a leak.The crank pully bolt does not have anything to do with the crank shaft seal leak. Thebolt is independent of the seal. To replace seal remove crank shaft pully and you will have access to crank shaft seal, pull out & replace seal.
Define crank turning lathe?
from what I understand its the same idea the way a crank shaft turns on a car, the idea is to remove material in the form.
How do you replace the crank shaft sensor in an infiniti G35?
It is on the front of the crank shaft and under the timing belt cover. You have to remove the crank pulley and all the belts and then the lower timing cover. It is not a job for a beginner.from : http://repairpal.com/crankshaft-sensor-569
What is a crank in a car?
Crank shaft
How do you remove the crank shaft pulley on 1996 Geo metro 1.3l?
How do I remove a pully from the drive shaft. The snap ring that holds pully on has been taken off.Itried a gear puller but it bends the pully.
