Depends on the number of feet from the breeching and how many 90 degree fittings are in place THEN check the NFPA 54
What is the developed lenght and a VENT STACK should be no less then 4" passing through the roof full size to prevent hoarfrost
To stack the chinaware/ silverware you should consider the size,shape and kind.
The relief valve should be at least as large (in BTU/hr capacity) as the input of the boiler. A 3.5 million input boiler would need then a relief valve to handle at a minimum 3.5 million BTU/hr.
NONE a boiler is a boiler and a water heater is a water heaterSEE ASME section IV or the NBBI
8 bit
In order to determine what size boiler you need, you will need to have a Manual J Load Calculation performed on your home.
in dynamic stack we don't have to initialize the size of array while in static stack we have 2 initialize it ......
This is the traditional system of drainage within buildings. The foul or soil matter is conveyed in a separate drain and stack from the waste matter. The size of the soil stack should not be less than the size of any soil fitting discharging into it, and in Nigeria, is generally not less than 100mm. The waste stack is similarly sized and is generally not less than 50mm.
output
downstream of a closet bend within 8 ft for three inch pipe and 10 feet for 4 in pipe at least half the size of the drain... unless it is stack vented then it would be full size of the stack right
Personaly I installed two boilers rather then one big one. I would imagine how many BTU out put you need that would dictate what size boiler one needed as one size does not fit all applications
The energy required for a boiler to produce 1kg of steam is dependent on the size and pressure exerted by the boiler. The output is described as the boiler horsepower. Once the dimensions are known calculation is a simple ratio.