0
What size torx bit is used for the brake caliper pins on a 98 Pontiac grand am?
Wiki User
∙ 14y ago
I believe that it is a T-55. A T-50 is just a tad too small.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Brake pads wearing on one side only?
You probably have frozen brake caliper slider pins or a frozen brake caliper piston on one side.
How do you remove the rear pads from a Girling caliper when no cotter pins visible?
BRAKE CALIPER PINSYou have to drive the pins out using a hammer and punch. The newer pins have a spring collar on them to hold them in the caliper.oldtimervolvosRus
Where are caliper bolts on 2004 Jeep Grand Cherokee?
caliper bolts are the two bolts that hold a brake caliper to the caliper mounting bracket. On both the front and rear of the vehicle (unless has rear drum brakes) the bolts have rubber boots around them working as slide pins.
How do you grease a brake caliper on a 1995 Corsica?
There are four steps on how grease a brake caliper on a 1995 Corsica. Some of the step-by-step instructions are purchase a silicone-based lubricant, locate the pins and boots, and then take the pins out.
What size are the pins on the rear calipers on a 2003 Dodge Grand Caravan?
What size are the rear caliper pins on a 2003 Dodge Grand Caravan?
What is procedure for compressing rear disc brake piston on 2006 Pontiac Grand Prix?
Screw the piston puck in clockwise. There is a tool for this (KN or KY) that is a box with little dowel pins to fit the slots in the caliper piston. What you are actually doing is resetting the parking brake. As the pads wear and you set the parking brake, each actuation of the parking brake foot lever ratchets the piston outward to componsate for pad wear.
Why would your left front brake lock up?
bad proportioning valve, stuck caliper or a restricted brake hose or line. i would check the sliding pins to the caliper first
Brake caliper removal 98 Dodge Durango?
Very easy. It has two pins that you remove.
What do you call the to bolts that hold your brake system on your disk on a 99 Chevy s10?
Caliper pins.
How do you change brake calipiers on a 1996 Chevy s10?
Remove wheel, remove the bolt holding brake hose to the caliper, remove the two pins that hold the caliper to the caliper bracket using a 3/8" allen wrench, remove caliper. Inspect brake pads and brake hose for damage, replace if necessary. Install new brake caliper in reverse order. Bleed system.
How do you take out the pins on the brake caliper on 1992 ford ranger truck there are no bolts or caliper bolts please help?
there are 2 rectangle pins that need to be pushed out with a punch/ screwdriver/ small pry bar
How do you change the brake pads on a 1997 Pontiac Firebird?
remove the wheel. on the back side of your caliper there are to slide pins that you need an Allen wrench to unscrew. unscrew them until they wont screw any more then pull them out. the caliper will be loose and the brake pads just pull out. slap your new ones in and reverse your steps and your good to go.
