0
What else can I help you with?
How do you port forward?
You access your router's configuration page. Then, you go to the page that has to do with the forwarding (Gaming,Applications,Security,etc). In there you type the port you will forward, TCP or UDP, and for which IP address.
What is sub net mask within the TCPIP configuration is used to distinguish?
The subnet mask within the TCP/IP configuration is used to distinguish the ? from the host address.
How is the TCP IP configuration information specified by the default router and dns server commands made available?
The TCP/IP information is supplied to any DHCP client on the network connected to the FastEthernet 0/0 interface of R1
Why router needs mac address?
the tcp/ip frame uses the ip address to send messages between devices (computers, printers, etc) on your network. This frame is inside an ethernet frame on the network layer. The ethernet layer does not use ip addresses at all, they use mac addresses. For an ethernet frame to travel through a router, it needs a mac address. Your router actually does not need an ip address. It will respond to broadcasts. In fact sometimes it won't answer to tcp/ip requests. Its job is to deliver the datagram to its destination more than it is to answer you (your computer that is). So sometimes a router will not answer a ping, but a computer on the other side of the router will answer even if there are several router in the path.
How many bits are in TCP IPv4 ip address?
a TcP IPv4 ip address has 32 bits.
Which protocol allows for the automatic configuration of host tcp ip address?
There are two ways to configure Ip address . One method is to do this manually .And other is to do this using dynamic host configuration protocol.
What part of the network layer address does the router use during path determination?
routers work at layer 3 (network) which usually means TCP/IP. Routing decisions are made based on a packets DESTINATION IP address.
What type of address identifies the source of data in a frame?
MAC
What displays utilities TCP IP configuration on Windows 98?
winipcfg
Why use DHCP?
In the LAN, its recommended to use DHCP because of the following two big reasons.Reliable IP address configuration: Using DHCP minimizes the human error caused while manual IP address configuration.Reduced Netwok Administration:Centralized and Automatic TCP/IP configurations.The ability to assign a full range of additional TCP/IP configuration values by means of DHCP options.
How do I block access to World of Warcraft with a BT Home Hub Router?
Blocking these ports should do the trick as they are the ports that WoW uses to communicate with the servers: 3724 TCP 6112 TCP 6881-6999 TCP
What command is used in Windows 98 to verify its TCP IP configuration?
winipcfg
