3/8" hex bit socket.
A 1997 Chevy Lumina has the following oil capacities: 3.1L V6 engine: 4.5 quarts 3.4L DOHC V6 engine: 5.5 quarts
T55
On my Chevy lumina it is located right by the gas take on the right side of the car.
Remove the 2 bolts from the caliper and then the 2 to the caliper bracket and just take off your rotor. Installation is in reverse of removal. Just make sure to put anti-seize on the bolts before putting them back in
I have a 1994 chevy lumina and it takes 4 quarts of transmission fluid when totally empty.
it takes about 2 to 3 hrs. Well if it takes you 3 hours, there is a problem. an hour tops
take it to a mechanic
take the tire off and then remove the brake caliper remove the brake pads take a c clamp and compress the brake piston replace the pads then put the caliper back on tighten the caliper bolts put the tire back on then turn car on and push on the brakes a couple of times
AnswerRemove wheel Remove caliper (2 15 mm head bolts) Remove caliper mounting bracket ( requires special large torx socket, forget exact size, available at Sears) Rotor will now fall off practically. after machining or replacement, reverse process above. Should take less than an hourThe torx socket size is T-60.
how u take off a transmission speed control sensor on a 1996 chev lumina
If they are disk brakes, then just remove the caliper, compress the piston, and install the new pads. If they're drum, then take it somewhere and have it done. It's way too easy to mess them up if your not experienced.
No u cant the bellhouseing are differnt an splines as well