0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
1996 buick regal 3.8 engine shuts off while driving.?
I had the same problem check the crank shaft position sensor i payed maybe 25 bucks for one and its not all that hard to change with the right tools.
How do you loosen a crank shaft bolt?
With the proper tools and the correct torque.
Where is the crank sensor located at on a 2004 Dodge Stratus?
It is located right behind the main crankshaft on the passenger side. You might have to take off the crank but might also be able to get your tools in there it depends on how they positioned the sensor.
Where is the crank sensor located on a dodge stratus 2004?
It is located right behind the main crankshaft on the passenger side. You might have to take off the crank but might also be able to get your tools in there it depends on how they positioned the sensor.
What tools are needed to change rear drive-shaft on 04 f350?
Impact and wrenches
What tools can you use to pull out a crank shaft pulley for a Dodge Intrepid 2002?
3 JAW PULLER. (You can buy it at any autozone, CAP or NAPA) $10.00 - $20.00 bucks.
How do you change a cam belt Renault clio?
Take to garage as special tools required to lock cams and crank
How much time to replace CV boot and shaft in ford windstar?
If you have the proper tools you can change it in about 1.5 hours or less.
Where are the tools in the vents?
by the vent shaft
How do you change a starter clutch in a 1981 Yamaha seca?
You need speciality tools and take it to a dealership that can work on it cause you can snap the crank
How do you remove the crank shaft pulley on a Grand Am SE?
its located on the front passenger side of the car.first take off the tire,then the inner fender and the crankshaft pulley will be right there. its also easier to do with air tools.
What tools are used for shaft mining?
The tools that are used in shaft mining are a cradle, a windlass, a bucket and a pick.shovels, carbide lamps, tipples, mules and ponies.
