0
What tools do you need to change the front brakes on a 1992 Chevy lumina?
Wiki User
∙ 12y ago
tire iron, flathead screwdriver for prying off the old pads, and get a general 30 dollar wrench set from auto zone. youll be good. go to expert village.com they have a great free video series on changing the break pads, which will be very similar to your lumina.
http://www.expertvillage.com/videos/rotors-replace-check-jack.htm
this video will show you, and the rotors if you need it too.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you install brakes on a Chevy Lumina?
This question needs to more specific. Disc or drum? Front or back?
How do you change a wheel stud on a 1995 1500?
HOW DO YOU CHANGE FRONT WHEEL STUDS ON A 1995 CHEVY LUMINA AUTOMOBILE?
What would a grinding rubbing noise be in the front tires of a 1994 Chevy lumina APV?
It could be brakes, bearings or something else altogether.
What will fix the brakes on a 1996 lumina?
Be sure to change both front brake hoses. I didn't and my calipers would lock up.
How do you change the right front low beam headlight on a 1998 Chevy lumina?
lift the hood it is on the right side.
Is the 1995 Chevy Lumina rear or front wheel drive?
front
What tools are needed to change the brakes on a 2000 Chevy silverado LT?
a torx bit size t-55 for front brakes
Will a hood and front valence from a 1992 Chevy lumina z34 fit a Chevy lumina euro sport?
Yes it will, I did the interchange on mine
How do you change a front wheel bearing on a Chevy Lumina?
Remove the tire and wheel from your Chevy Lumina. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new front wheel bearing.
How do you change front brakes on 1972 Chevy Chevelle?
get a chiltons repair manual for chevelles and read up.
Is the 1997 Chevy Lumina rear or front wheel drive?
Front wheel drive.
How do you change the front brakes on a 98 Chevy lumina?
you need two special tools 1. A T60 torx bit to remove the caliper bolts 2. A caliper piston compressor two large c-clamps will work but compress evenly and SLOW
