I would suggest a 4.3 liter V-6 fuel injected. That is what I have in my truck and I havent had any problems. I have no ideal where to get one in Canada.
There are many places to purchase a Chevy in Canada. One place is a used car dealer. Another is a Chevrolet dealer which are located throughout Canada.
The starter should be place around the bottom front of the engine by the oil pan...
take it to a Chevy place
Place something to catch the engine coolant beneath your 1990 Chevy Corsica radiator. Remove the radiator drain plug with a 9/16 ratchet. The engine coolant will drain out.
Chevy did not have a 350 in 2001 engine options were 5.3, 6.0. or big block
Yes. You will need to mount the engine 60degrees, however.
You can drive your 2005 Chevy Trailblazer 4.2 liter engine with salt the air box cover in place. It is not recommended to do so, because cost particles can get into your engine.
between the engine and the muffler underneath the car would be the logical place.
You need a scan tool. However, you should not turn off the light without repairing the problem that is causing the light in the first place.
if it is a hei ignition there is a place on the distributor cap that says tach.
You fill in the same place you check it at the top left above your engine
That requires an engine scanner to do that. If you don't repaire what made the light come on in the first place it will just come back on.
Check out some HHR forums. Someone there should be able to help you with this! I would try and answer but I have the HHR SS so it's a different engine so I am not sure if it's in the same place. http://chevyhhr.net Tell them Chevy SS sent you.
Any search engine would provide the answer to this question simply by inputting the words Klondike and gold. The Klondike Gold Rush took place in (should anyone be surprised?) The Klondike, which is in Yukon, Canada.
St. John's Newfoundland Canada is the stormiest place in Canada and the stormiest place in North America.
same place as all cars. Dash, Engine exc.
A V8 engine is put in a Chevy Astro van by removing the existing engine and removing all unused accessories. The engine can then be put into place, bolted to the transmission, and everything hooked up.
find a 350, build mounts to mount the engine, find a tranny for it, and install. only.. if the engine fits in the first place, and if you need to ask, you should probably find someone that has done this swap (if its possible) or has experience with 350's find a 350, build mounts to mount the engine, find a tranny for it, and install. only.. if the engine fits in the first place, and if you need to ask, you should probably find someone that has done this swap (if its possible) or has experience with 350's
Canada Place was created in 1986.
How do you change a flywheel on a Chevy truck? You can remove either the engine or the trans. Once you have either removed just remove the bolts holding the flywheel in place.
The Chevy Malibu
Disconnect the battery for 20 minutes. This should reset the light. Of course if you do not repair the problem that caused the light to come on in the first place, it will just come back on.
Not positive but they should just pound in place I would think.