I don't know if this makes any sense or not but my owners manual says it is a Fuse TURN B/U 20 amp. This is for the turn signal and the back-up lights Fuses tend to be color coded, making life so much easier. A 20 amp fuse is the yellow fuse and run about .85 cents each. Look at the fuse box cover (on your left near the peddles) on the back of that should be the set up for your fuse box, what size they are and where they are positioned in the fuse box.
From the trunk.
It will be under the dash on the driver side. It is clipped in just to the right of the steering column.
In the fuel tank.
put a new bolb in them
no,will not line up
In 1992, it was called the Sunbird. The Sunfire did not come out until 1995
170 km/h or 106 mph.
Passenger side, near the firewall inside the car.
the part with the spring goes towards the motor,
With a BFH ( Big Friggen Hammer)
how do you remove the turn signal assembly on a 1989 Pontiac Bonneville
The 1992 V-6 Pontiac Sunbird radiator drain plug, is located on the bottom of the radiator. The drain plug can be removed with a 5/8 socket.
http://www.driverside.com/car/pontiac-sunbird-1992-1008-2054-0There is some information about the car, what do you want to know- edit your title and provide more information so we can better help you.
is it not on the side of your car????? right along with "sunbird" :| if its not..Sorry...weird.
1992, v6, pont. sunbird, quit running going down road, everything is still working and okay but won't fire up
open the hood, grab ahold of the black pod which is on the signal light , turn and pull out. light just pulls out of socket , replace by pushing in new bulb then put back in slot of signal light holder and twist to tighten again,,,,,,done deal
One of them is behind the instrument cluster and the other is on the side of the transmission. Ray
Which engine?? The 3.1 V6 does not adjust. You simply torque them to 20 foot lbs.
You don't- it's controlled by the PCM. If is has a 2.5 engine you cann't adjust the timing
the tube going into the engine where it says OHC 2.0 in the back
unclip one end and unbolt the other be careful of the plastic fuel line
If you have 15 inch wheels on a Sunbird GT the size is 195/65-15. If you have 14 inch wheels the size is 185/75-14. I hope that helps.
Between the head and the engine block. This is a BIG job and I sugest taking it to the garage.
No. There would be a gasket between the head and the block, though.
I have a 1992 Pontiac Sunbird with 2.0 four cylinder in it, just found the crank sensor on it, to replace it. It is located on the FRONT side of the engine, below exhaust manifold and just above the A/C compressor. HOPE THIS HELPS SOMEONE ELSE!