0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How long does it normally take to replace brake lines on a 1995 Toyota Corolla?
It should only take about an hour to replace the brake lines on a 1995 Toyota Corolla. The exact time will depend on your experience with replacing brake lines.
What kind of tubing is similar to steel brake lines?
Copper/nickel alloy tubing is easy to work with and doesn't rust.
How do you bleed the brake lines after replacing brake pads on a dodge Dakota?
If you did not open any brake lines and only replaced the pads there is no need to bleed the system.
2001 Olds Alero-no brake pressure after replacing front brake pads rotors and calipers why?
It sounds like you have air in your brake lines. It sounds like you have air in your brake lines.
Replacing rear brake lines 1999 Chevy blazer ls 4x4?
The brake lines can be replaced by removing all of the retaining clips. The brake lines will need to be disconnected on both ends. Reverse the process to install the new brake lines.
How do the brake lines from the master cylinder accommodate the fact that the wheel can move in relation to the body?
While the brake lines from the master cylinder are metal through most of the car body, the lines from the body (or frame), to the wheel cylinders or brake calipers are flexible, high pressure, rubber composite tubing.
What is the cost of replacing all of the brake lines on a 1995 Buick Park Ave?
Why would you want to replace all the brake lines? You can flush the entire system and install fresh DOT3 brake fluid. I can see no reason to replace all the brake lines. Why are you doing this? Unless your brake lines are rotted out or someone has cut them... there is no reason to replace all four lines.
How do you fix a brake line on a 96 Corsica?
The brake lines on a 96 Corsica can be fixed by replacing damaged sections with new lines. This will improve braking and prevent catastrophic failures.
What diameter are the steel brake lines on the 1999 Chevy silverado 4x4 ext cab?
The Brake line tubing is 3/16 single flair front is double flair
Do brake system need to be bled after replacing lines?
Yes. You need to get all the air out if the system
How do you replace the brake lines on a 1994 Chevrolet Beretta?
Measure each brake line and go to the parts house and get the necessary lines. You will need a tubing bender. Remove the old lines one at a time and bend as needed. install the lines and then fill the master cylinder and bleed each wheel.
What would cause air in the brake lines of a 1998 ford escort?
When replacing brake lines, wheel cylinders or calipers air will get into the lines because they were taken apart. Usually air gets into the lines before you work on it because the master cylinder got too low on brake fluid letting air into the lines. Also a bad seal on a caliper piston and a brake wheel cylinder will allow air into the lines.
