0
What will a break in the ignition coil wire or cap do to voltage?
Wiki User
∙ 16y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the primary parts in an ignition system?
Okay it break down like this; 1, the ignition. coil. 2, trigger or ignition module, 3 spark plug wire, 4 spark plug. You dident ask how it works. Wanna Know? I'm kolher. The primary system is the the low voltage side, points, ignition module, primary side of ignition coil and ignition switch. The secondary windings of the coil, coil wire, distributor cap, rotor, spark plug wires and spark plugs are parts of the secondary system.
Ignition coil wire diagram?
The ignition coil wire diagram can be found on Mustangs And Fords website (link to diagram below).
Where is the ignition coil wire in 92 cavalier Iam trying to hock up Rpm Tachometer but Iwant hock up the ignition coil wire from inside the car Is there an ignition coil wire tat runs inside the car?
no
Where is the coil wire on a 1995 Buick Riviera?
There is no coil wire. There is a coil pack and connected to the coil pack is the ignition control module.
How many turns of wire in a coil to produce 240V?
it depends on what is your low volatage. the turns of coil it's according to what is the voltage they are,When the coil / coil is equail voltage/voltage
Which is better adding coils or upping the voltage to improve an electromagnet?
Upping the voltage is the easiest method to do but you have to be careful of the insulation rating of the wire in the electromagnet coil. As the voltage goes up so does the current and the heat produced by this action. By over exceeding the voltage rating of the wire this will cause the insulation to break down and short the coil out.
What wire on your ignition coil on your 99 Cherokee XJ is negative?
The 1999 Jeep Cherokee ignition coil used a black wire for the negative wire. The negative wire should be on the left post.
Where is the coil wire on 1990 Chevy Celebrity?
The coils are bolted to the ignition control module, there is no coil wire as such.
What would cause vw golf gti 1992 ignition coil live wire to burn out?
vw golf ignition coil wire to burn out y
Why would an ignition coil keep burning out on a 1971 Barracuda with electronic ignition?
Make sure you have only about 8 volts going to it not a full 12. There is a resistor wire that should cut the voltage.
Why does your 79 cj only have 10 volts at the coil while running?
The ignition only needs 12 volts for starting. You`re wiring harness has a resistance wire or ballast resistor to drop the voltage to keep the ignition coil from burning up.
How do you wire a 75 350 changing from old dist to electronic ignition for the new dist?
I've never seen a 75 Chevy 350 that didn't come with HEI, as it was a mid-year introduction in 1974. However, if such a thing as a 75 Chevy with point distributor exists, there would be a steel wire running from the ignition switch to the hot side of the coil. The steel wire would need to be replaced with a copper wire. The steel wire acts as a resistor to reduce the voltage to the coil, which is not necessary on an HEI, and would limit the total voltage the coil could produce.
