it will not work.
why the supply is given to the stator of dc generator give answer
motor will run at a faster rate.....
This is how an induction motor normally works, hence the name. The supply voltage is connected to the stator winding(s) and a current is induced in the rotor. A synchronous motor, on the other hand, will have current supplied to the rotor through slip rings and brushes. The rotor current is generally supplied as DC though, or else rectified in the rotor.
in 3 phase motor u1,v1,w1 give to the short terminal and remaining v2,u2,w2 give t0 the in coming power supply of 440v
as both supply is given from same phase then the bulb will glow as normal
An induction motor has no excitation, so the question is about a synchronous motor. The rotor speed is determined by the supply frequency. For a given supply frequency and mechanical load, the excitation current can be adjusted to give the best power factor.
its impossible to give suppy to rotor of an induction motor,because of it a closed path for circulating currents.
No. you cannot connect a 415 V to a 380 V motor. in case if you want to do that, you need to increase the number of turns in all the three phases of winding as per the turns calculation.
the appliance will burn out, eg if it is a 60 watt light bulb it will burn at 120 watt for as long as the fillament can take it and that wont be long
If you want to control induction motor using a control relay give neutral directly to the one point of coil of relay & one point of coil of contactor then give control supply through push button to second point of coil of relay. use one NO point of relay and give supply to coil of contactor. and also use one NO of contactor for holding the contactor & take OFF (NC) in the starting to stop motor after complition of work. It is jut like an Direct On-line starter.
I had a friend who had a shunt in their brain and the doctor said if he ever had pains he should go to A&E immediately because it has probably moved and is lodging itself further into the brain and has caused internal bleedinggo to A&E!!!
It could be that you starter motor is going to give you trouble. This used to happen on Ford Transit Vans