No. you cannot connect a 415 V to a 380 V motor. in case if you want to do that, you need to increase the number of turns in all the three phases of winding as per the turns calculation.
LT motors are those motor whose voltage rating is less than 415v.
The main application for a core type transformer is to increase voltage from a standard 240v supply up to 415v instead of using a 3 phase supply.
The line current would be the same if the motor were connected in delta. The current can be based on the rule of thumb which says 7 amps must be allowed for a 1-HP single-phase motor on 240 v. A 2.2 kW motor is three times as powerful, and on a three-phase supply of the same voltage (240/415) it would draw 7 amps.
Theoretically, you could connect three identical lamps in star (wye) and connect this to the three line conductors. But as you asked how to connect a (single) 230-V lamp to the supply, then the answer is by using a step-down transformer.
415v air circuit breaker acceptable value of 0.01 ohms and lessthan
no
That is a big motor, 70-80 HP and you should check with an electrician. It depends on what type of motor it is and what type of load it is driving.
Yes it can run because motors have 10% voltage variation tolerance so it can operate between 380v - 440v band.
Yes, it will run drawing little more extra current in similar conditions. The motor is expected to be running in lesser rpm as well.
No you can't use a 415v motor in a 240 v socket.
The three coils are actually called UVW. They are called that because they are for the three phases of a 415v supply.
LT motors are those motor whose voltage rating is less than 415v.
Current shall increase while you apply 415V for operating it and will decrease the rpm to a much low level.
240 or 415
Answer for European SystemsThe nominal line-to-line voltage used for single-phase supplies in Europe is 400 V. In the UK, this voltage is allowed to vary between -6% and +10%; in other words, it can vary between 376 V and 440 V. So it would be quite acceptable for a 380-V and a 415-V motor to operate on this system.
It is not advisable to do so. You may burn the winding, insulation may fail.
415V 3 phase is the line to line voltage. The line to neutral of this supply is 230V single phase. Therefore you use one of the phases and the neutral.