To make a 318 into a slant 6 engine on a 1970 Dodge Dart you will need new engine mounts, fuel lines, and bigger radiator. What needs to be done first is to remove the old 318 and add the new engine mounts first. This is not something that should be done if you don't have the proper tools and equipment.
put the tank up in place and then use the 2 straps that hold it up and bolt the straps down and the tank is now in place, hook up the wire or wires to the fuel sending unit and your done.
A dart board can have darts attach to it through a variety of ways, but usually this is done through magnets or the dart puncturing the board. If you dug the penny into a dart board that is supposed to be punctured, it might stick in there, but on a magnetic board, you would not have much luck since pennies are not made of a ferrous metal.
The cost to get your 1969 Dodge RT done by overhaul will depend on the area where you live and its condition.
Back in 1970 all engine controls were done by mechanical means. The answer is no, there is no PCM on a 1970 VW Beetle.
Yes, but to be done properly it requires an expensive kit from Dodge/Mercedes.
Done means that the system is done flashing codes. If that Is all it flashed, there are no codes.
Self test has completed.
Sure, it can be done.
yes it will, only a few mods will need to be done
you could do the forces of gravity pulling the darts down... or maybe the the pyhsics of a dart colliding with an object
you have to call the vin number into the dodge dealership and they will give you a color code that was how ours was done anyways
Grab and twist to the left... DONE!