the hot wire goes to the starter and the ground wire bolts to the engine block.
Red is hot, black is not.
show wire names for car stereo
The ignition wire diagram for a 1985 Cutlass Supreme 2-door, can be found in a Chilton's Automotive Repair Manual. This manual can be purchased at many automotive parts stores, or found in some libraries.
If the vehicle is a Front Wheel Drive vehicle, the starter will be located in the front lower part of the engine. Just look for a large black wire that is attached to the motor and just follow the wire and it will lead you directly to the starter motor. Good Luck.
The 1990 Chevrolet Corvette IAT sensor does have two wires. The sensor has a ground wire and a positive wire.
The ground wire is melting on the 1990 F150 when trying to start the vehicle because the wrong wire is being used as a ground wire. The wires are color coded. Perhaps the factory made a mistake with how the wires were hooked up.
Under neath the speaker insulation, behind the dash board. left of the glove compartment.
you can pull the fuse in the fusebox that controls it or you can find the horn and pull the wire off of it.
its a ground wire
It is in the top left section of the hood. the top left if you are facing the grille of the car. it has a hose connected to it and it has to have a ground to it. on my car it didnt have a ground so it was not working i had to get a new blower motor but it has to have a ground. i used a screw and wrapped a wire around it. it does not blow very hard. hope this helps.
This is what I have had to do for my 94 cutlass supreme. Hold the hood release wire lever open from inside the car with a something - a screwdriver or some such thing. Then just pull up on the hood and voila, it releases the latch.
It is the ground wire for the fuel pump. The Red wire is the power wire for the pump. the dark blue is the signal wire for the gauge and the black is the ground for the gauge.