answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What wires do you need to get an alternator out of a 3.1 Isuzu to work in a 3.0 Isuzu?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will alternator still work if the gauge is not?

An alternator does not need a gauge to work. It is used to monitor the output of the alternator.


Would a bad X-10 relay box cause the fan on the AC not to blow on an Isuzu Rodeo?

A bad alternator will cause the fan blower not to work properly. Have the alternator tested!


How do you time turbo on 2001 Isuzu npr need repair?

i have 2001 isuzu npr motor 4he1 i need wow the turbo no work


How do you replace an alternator on a 1994 Nissan truck?

on yours, you will have to remove the bottom shield and work from the bottom of truck.Remove wires from alternator,remove pivotalbolts and remove alternator and replace and tighten belt back.


Why isn't one wire enough to make it the work?

Because you need 2 wires to go into the ___ to make it work. You need 2 wires to make the electricity go into the ___ equally.


Would a bad alternator make the wipers not work on 1995 altima Nissan?

no if your battery light is on and the brake light on then your alternator need to be change


Will a 1999 Isuzu Rodeo headlight work on a 2001 Isuzu Rodeo?

Yes


Will a 98 automatic transmission work in a 99 Isuzu rodeo?

A 1998 automatic transmission may not work very well on a 1999 Isuzu Rodeo. This is mainly due to the incompatibility of the two engine systems and some modifications may need to be made.Ê


Voltage regulator 1995 eagle talon located?

Its inside the alternator. Its not really something you can replace. If your voltage regulator doesn't work, you need a whole new alternator.


How do you replace the alternator on a 97 Isuzu Rodeo?

DISCONNECT BATTERY FIRST!!!!!. The alternator is located on the passenger side of the motor at the bottom. There is a bracket attached to the motor and the alternator. You need not take the bracket off to remove the alternator. Two bolts hold the alternator to the bracket. One bolt is on the front top of the alternator and one bolt is located on the bottom front of the alternator. The bottom front bolt is attached to the tension adjustment for the alternator. Loosen the tension screw then remove the bolt going through the tension adjustment. After you loosen the top, front bolt, the alternator should be loose enough to move side to side. Remove the top, front bolt.Now you must disconnect the alternator from the power supply. Behind the alternator is a screw with a wire attached via nut. Remove this wire. Nextly there is a series of wires with a plug on the end. It is plugged into the side of the alternator. Uplug this item. You can also access both of these from the passenger side front tire well.Something to consider is that remanufactured alternators in Rodeo's as well as the Honda Passport (which has the same engine as the Rodeo) do not work and the problem(s) associated with a bad alternator,ie; not charging, no fan blower, battery light and brake light on, still exist after replacing alternator with reman. Use a factory original alternator if possible. It will cost a little more than a reman but will most likely save you a lot of time and headache!Hope this helps you out!!


Will factory turn signal mirrors work on a f150 if the original mirrors didnt have turn signals?

factory turn signal mirrors were an extra option for purchaser when new. vehicle may already have wires and just need hooking up,so yes these mirrors will work if no wires already installed, you will just need to run extra wires to make them work


Why would starter and heater fan not work and other things OK?

I have an Isuzu Trooper II 1985 and when the heater fan stopped working it was because the alternator was going out. I found that out a few months and a few dollars later, unfortunately.