you need to use a battery charger or jumper pack to power the wires on the window motor.
inside of the door of the Monte Carlo there are two tan wires, a larger one, a smaller one, a blue wire, and a black, try to get some shrink rubber for wires or electrical tape either one, I prefer the rubber all you need to do is put it on one end before tieing the two wires each together and then take a lighter and heat the rubber and it will shrink around the exposed wires. When you put the door trim back on the locks will work I recently worked on a 1992 Monte Carlo with the exact problem.
one to the batery one to the ignition posibly one to aldinator
Replacing the starter on a 1999 Monte Carlo is fairly easy to do. The car will need to be jacked up to reach the starter. The wires will need to be disconnected from the starter before removing it. After the wires are removed, the starter can be taken down by removing the two bolts. After the starter is removed, replace it with a new one.
Yes... Where all the spark plug wires go into the same spot.Yes... Where all the spark plug wires go into the same spot.
There are bolts that you must remove in order to take out the front seats of a 2002 Monte Carlo. There are two in the back of the seat and two in the front of the seat. If you have heated seats you will also have to remove the wires for that before you take the seat out.
Replace your plugs and wires. Just happened on mine at 118000
unhook the battery, remove the cerpintine belt, remove the wires, remove the bad alternator, put on the new alternator, replace the wires starting w/ the negative one, replace the cerpintine belt, tighten the belt.
Put em back the same way you took em off silly.
I have a 01 Monte Carlo SS and my ground is under the backseat it was profesionally installed but it was pretty easy to do everything in the back just snaps off and snaps back in to place, but when you take the back seat out there is alot of metal and its easy to screw it to the frame of the car.
looking under the firewall, follow the hoses and wires that go through the firewall. One will have enough room to squeeze the wires through. Make sure that you can reach the wires on the other side of the firewall as well.
remove pwer window switch disconnect wires. using another wire, bridge the wires in swith to complete circuit window will go up
replace the spark plugs, plug wires, distributor cap and rotor, set the timing, replace the air filter and fuel filter.