My trans had that problem and it was the yoke on the drive line going into the rear
trans needed lubrication takes about 15 minutes to do disconect drive line u joints
at rear end and slide drive line out and lubricate the splines that go into transmission
with grease a heavy bearing grease worked fine for me.
There are several things that can cause your transmission to slip, while first pulling out. The most common cause is a worn drive gear.
No, but it could cause higher then average wear on the transmission.
You can tell if the transmission, in your 1998 Chevy Malibu, is going bad. If there is a whining or clunking noise. The transmission might cause your engine to install when you are stopped with your foot on the brake.
Try your tcc solenoid on the transmission
There are several things that can cause shifting problems in your 1989 Chevrolet Blazer transmission. The most common cause of shifting problems is a lack of transmission fluid. Broken shifting forks can also cause transmission shifting problems.
A worn transmission gear can cause a Chevy Impala to whine when the gears change. A bad fan belt can also cause this.
The same thing happened to my dads 96 Chevy S-10. The transmission was rusted not allowing it to shift. I would have the transmission checked out.
Yes, and that will cause shifting issues.
There are several things that can cause your 1995 Chevy Cavalier transmission not to go into drive or reverse. The most common cause is a lack of transmission fluid. A broken shifting fork will also cause the problem.
Oil leak and overheating?
There is a problem with the valve body in the automatic transmission. It may stay like that, or it may get worse - no accurate prediction can be done without pulling the transmission apart to see what the cause is.
Could be several reasons, need to know aprox where it is leaking from.