The first thing it sounds like is a vacuum. if not, check timing.
You should be able to. I have a 96 engine and auto tranny in a 91 model lsi hardtop. Everything works great.
Yes, but you have to remove the automatic transmission housing, and you have to replace the Torque Converter with a standard transmission clutch that matches the type of transmission with which you are mating the engine.
If the tracker is a "standard shift" not automatic transmission. You could pop start the engine by putting the car in 1st gear, with the clutch pedal down and the ignition on. Roll the car and once car is rolling release clutch pedal. Vehicle should start, hope this is what you ment by "manually".
Near the back of the Engine in the middle.
On my 1996 Geo Tracker automatic transmission 4wd it's located (in the engine compartment) on the passenger directly behind the intake (to the driver side of the battery) I hope that helps
The question is if the transmission is a standard or an automatic, if it is a standard then the transmission is located directly behind the bell housing which is bolted onto the rear of the engine, if it is an automatic then the transmission is bolted directly to the rear of the engine
Well depends of what kind of hard start and transmission your car may have. It can be and electrical, transmission, engine issue
It is between the engine and transmission.
Standard cab with a 4 cylinder engine and automatic transmission is rated at 5600#. Standard cab with a 4.3 V6 engine and automatic transmission is rated at 6000#. Extended cab with 4.3 V6 engine and automatic transmission is rated at 5500#.
Depends on which engine it has and if it is a standard or an automatic.
Can a 2001 Suzuki Vitara 2.0 Engine be swapped with a 2001 Chevy Tracker engine?
No. The Prism motor is a Toyota motor and side mounted. The Tracker motor(suzuki) is mounted with the engine from front to back, so it will not work without a lot(I mean a lot) of work to do it.