Make sure all of the wires on the coil are tight and if they are take it to a speedo shop for tach repair.
Most likely cause is a failed engine thermostat.
I very much doubt it.
Check the level of the oil in your engine. If it's ok, then you must have a faulty gauge.
It means that one gauge is not in the safe zone. Check the engine temp, oil pressure, battery/alternator voltage,It means that one gauge is not in the safe zone. Check the engine temp, oil pressure, battery/alternator voltage,
I think is 14 gallons.
The most common reason for a 1996 Chrysler Cirrus odometer and RPM gauge to stop working is a fuse. If the fuse is removed from the dash and replaced, often times the odometer and RPM gauge will begin working.
Engine is overheating, faulty gauge, faulty temp sensor......
The oil gauge does not have a reset. Is malfunctioning, the sending unit has probably failed.
yes it can
ignition module , computer , wiring or fuel system problem. when engine stops rpm gauge goesto zero.
It goes up while driving and down when you're idle....that's normal
Most likely cause is a failed sending unit in the tank.