Here are some reasons why the fuse has blown: * The unit's compressor pump has seized-up or failed in some other way, so is overloading the motor and that has made the fuse blow
* The unit's motor has developed a fault, such as a shorted winding, which makes it take too much current and that has made the fuse blow To be able to investigate either of those reasons you would need to call a Heating, Ventilation and Air Conditioning (HVAC) technician to use his test instruments, tools - and experience - to diagnose the problem and advise you what can be done to fix it.
Not sure but just reset your breakers
I know what would happen. The three amp fuse would blow. Any device that is plugged into a receptacle with out having sufficient resistance to limit the current flow will dead short the circuit and cause the breaker that feeds the circuit to trip. In this case the fuse being of a lower rating that the feed breaker the fuse will blow without tripping the receptacle's feed breaker.
It depends on what you are powering with the circuit, but probably not. The 1.5 amp fuse would blow in normal operation of the device.
The fuse is made to blow at a set amperage to protect the wire from overheating. Using anything but the fuse may cause the circuit to work but could most certainly cause the wiring to overheat and burn if it is overloaded.
To use 1 megawatt you would need to switch on five hundred 2-kilowatt convectors. That would blow the fuse :)
What would cause your fuse to blow when you turn on your lights on your 1993 mazda 323 the fuse to the tail lights on dash lights blow?
An Electrical Short Cut somewhere would cause it to blow the fuse. A pinch wire would ground the system, and cause a shortcut.
i just changed my fuel pump and it has not blown the fuse so i would say that it can cause the fuse to blow
the relay switch maybe stickin
Not necessarily. It can blow because the circuit was overloaded and pulling too much current. That would cause the fuse to overheat and blow.
A short somewhere could do it.
There is probably a short in the wiring.
from seeing your ugly face
The starter is failing.
blow fuse, bad motor, bad switch or wiring
You have bad ground in the switch
Short to ground or overloaded circuit